mxer147's latest activity
-
mxer147 reacted to Tank6x2's post in the thread What have you done to your square lately?? with
Like.
No trust DD - Ok tonight, I’ll throw it in the back seat - AGAIN!! -
mxer147 replied to the thread 80 sq body.I’d go ride that dirt bike first and then buff out the green paint then wax. Nice rides and good to be back home where it belongs.
-
Newbie here. I've owned this truck for 32 years, sold it and just bought it back. 454 4 speed granny 3/4 ton
-
mxer147 replied to the thread What have you done to your square lately??.No, it’s an isocyanate activator mixed 8:1 which hardens the oil based enamel paint.
-
-
mxer147 reacted to PrairieDrifter's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with Like.
I've seen a lot of you guys posting your free hauls. I've been over here patiently waiting for my turn! Finally got it lol. Free 99...
-
mxer147 reacted to Mr Clean's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with Like.
Went to a auto Swap Meet today. Found a few goodies. Seats for the Mistress, Hi Lift jack for the Extracab. Small cap HEI distributor...
-
mxer147 reacted to bucket's post in the thread Scores from DIY Parts Yards, Pull A Part, U Pull It etc with Like.
Not from the junkyard, but close enough. Today I picked up these old lightweight plastic race seats that were put out for free at the...
-
Picked up a "broken" 3D printer for $30. Needed a new cable. Got a whole cable kit for less than $15 shipped. Slapped the laser engraver...
-
mxer147 replied to the thread What have you done to your square lately??.Rust oleum hood underside and some associated parts. Used some enamel hardener this time.
-
-
Holes drilled Hung it back, lifted the whole thing enough to remove the steer wheels so I could throw the bolts through and tighten...
-
Drove it. Filled it up and drove to nearby town, about 1/2 a tank away (15 miles). Just kiddin of course. Beautiful day for a drive.
-
mxer147 reacted to Tank6x2's post in the thread What have you done to your square lately?? with Like.
Spent the last couple of weekends Attempting to stay focused on just the firewall- cutting it apart, fabricating the brake support...
-
If you need the best scale plates made, see my buddies page. https://www.rcplateshop.com/
-
New Toro Z Master 60"
-
I filled all the speaker holes (and cracks) with fiberglass/bondo and wrapped in leather. btw I like the seam to just be around the...
