Recent content by MrMarty51
-
Rock Auto Closeout Sale 1987
Amazon does have official AC Delco distributors so warranty for components purchased from the official AC Delco sites is without a question. -
Hydroboost - Hard Pedal
I nominate You Super Tech. You dont miss a thing. :birgits_tiredcoffee -
Hydroboost - Hard Pedal
I do not know what the internal differences between the two types is, I have never dismantled either one to find out. The parts man at that store is a very good friend and had worked as a parts man at one of the local GM dealerships for many years. With My phone call He investigated what had... -
Hydroboost - Hard Pedal
A guy over in these parts had a SB GM pickup that had been converted from diesel to gas. For some reason he thought the master cylinder had gone bad. He got a replacement MC and stuck it on the hydro boost. Then his problems multiplied. After richard cranium with it for several months he asks me... -
-
6.2 alternator conversion
2-5/8ths inch pulley is the correct size fir the diesel engine tachometer sensor.- MrMarty51
- Post #14
- Forum: Electrical & Audio
-
6.2 alternator conversion
Also, if @Frankenchevy got a gas burb, and if You would like the newer FFM fuel filter system let Me know. I have a good spare unit setting on the bench. It does have a new seal kit with it.- MrMarty51
- Post #6
- Forum: Electrical & Audio
-
6.2 alternator conversion
And also. I dont remember the diameter of the pulley for the alternator that drives the tach signal so be sure that if You have the alternator that came with the donor bracket that You measure both pulleys. If one pulley is larger than install that pulley onto Your new alternator as the reman...- MrMarty51
- Post #5
- Forum: Electrical & Audio
-
Looking to buy our first 6.2
Is Your new BURB a gas enjun ? I do have a FFM UNIT from my 2000 K3500 6.5 that I would give to Yoi if your new burb is a diesel. It even comes with a new from Leroy Diesel seal kit. And Leroy also sells the components to convert it to a feed the beast mod.- MrMarty51
- Post #25
- Forum: Diesel 6.2, Conversions Cummins, etc.
-
-
Home Made Tire Chain Snubbers
This is a hook that holds the cross bar links of a tire chain, to the side bar chains. The tarp stretcher hook is a side bar link with one side sawed through then the ither side heated to red, then twisted 90*and then welded to the criss bar retainer. Then more side bar links are sawed and...- MrMarty51
- Thread
- Replies: 0
- Forum: Off-Roading
-
4L80E Information Thread
Then a gauge rated at about 500 PSI would be a wise choice to allow for spikes in the system ? Thank You for the response.- MrMarty51
- Post #15
- Forum: Automatic Transmission
-
4L80E Information Thread
Filling a gauge pod on the dash of My 2000 K3500 that runs the 6.5 diesel and a 4L80E transmission. The post pillar pod it has the boost, EGT and transmission temp gauge already installed. The pod on the dash has a two position fuel pressure gauge and a temp gauge reading from the rear of the RH...- MrMarty51
- Post #13
- Forum: Automatic Transmission
-
Scores from DIY Parts Yards, Pull A Part, U Pull It etc
I will check that this morning, bephore heading to working. I need to check the oil on that car and on the 88 Buick Century. Have not had the hood opened on the Buick phor about a munth, it most likely is about ready phor a fifth, oooops, quart, yup a quart. :) -
4L80E Information Thread
The tuners said there would be no problem, but, I tend to be an overthinker and a worry wart to boot. New Stock optimizer with injectors set at 1950 PSI will produce no where near 800HP and most likely about 300 at the very too side. Thank You very much for the info.- MrMarty51
- Post #10
- Forum: Automatic Transmission
