Matt69olds's latest activity

  • Matt69olds
    Matt69olds replied to the thread Pumping Air to a Catalyst.
    The temp switch automatically locks the converter if it gets too hot. The theory is a locked converter will reduced heat. Of course...
  • Matt69olds
    Matt69olds replied to the thread headlight/seat belt buzzer.
    I think the difference is for seat belt warning. There is a trigger wire for the seat belt switch in the seat belt latch, and another...
  • Matt69olds
    Matt69olds replied to the thread headlight/seat belt buzzer.
    The easiest way to disable the key warning is to unscrew the door jamb switch, and disconnect and tape off whatever wire isn’t white. If...
  • Matt69olds
    For some reason, I can’t post pics!! What’s up with that?
  • Matt69olds
    Over the winter, my son and I have been fixing/updating some severely neglected things on his 92 Yukon. Things like replacing the...
  • Matt69olds
    Matt69olds replied to the thread headlight/seat belt buzzer.
    I’m curious, why do people despise them? I get it, the key in the ignition chime is annoying, but the headlight warning would be worth...
  • Matt69olds
    Matt69olds replied to the thread Pumping Air to a Catalyst.
    GM warmed the converters in the most reliable way at the time. Meaning they calibrated a cold start with increased idle speed, delayed...
  • Matt69olds
    Matt69olds replied to the thread TH350 Removal.
    If your going to add a plug, drill a small hole where your going to install the plug and let it drain that way. Much cleaner that way.
  • Matt69olds
    Matt69olds replied to the thread TH350 Removal.
    If the trans has a drain plug, use it! If it doesn’t have a plug, now would be the ideal time to install one!!
  • Matt69olds
    Matt69olds replied to the thread Accelerator Cable Adjustment.
    How about some pictures of what you’re working on? What carb/intake, are you using? It might be quicker and easier to just buy the...
  • Matt69olds
    The clutches have definitely seen some heat, but they aren’t burnt. What’s the pump look like?
  • Matt69olds
    Raise the transmission as high as possible, get as much clearance as possible between the pan and the crossmember. If that doesn’t...
  • Matt69olds
    Lube the seal with vasoline, place the o ring in the case, right up against the step it seals against. Lube up the cover, put it...
  • Matt69olds
    On a somewhat related subject: my wife and I like to go to flea markets, pawn shops and swap meets. One of the pawn shops I frequent had...
    • 20141028_155830_Original.jpeg
  • Matt69olds
    On my truck, I ran the coax from the center of the roof down the center of the rear window. From there is zip tied to the floor until it...

Forum statistics

Threads
45,611
Posts
987,400
Members
38,695
Latest member
72cuda440
Top