Matt69olds
Latest activity Postings About
-
-
Matt69olds replied to the thread Strange square holes in case....This^ Use a small punch thru the hole to push the snap ring out of the groove, then use a small screwdriver or pick to pull it out. -
Matt69olds replied to the thread 700r4 problems.Fluid over full after sitting a few days is normal. The converter will naturally drain into the pan.
-
Matt69olds replied to the thread CUCV Torque Slip (TH400).Most factory converters will have a stall speed of around 1600-2200. I know the place I buy remanufactured converters won’t sell a...
-
Matt69olds replied to the thread Strange square holes in case....And another case for sale on EBay. Do you have a service manual? Once you get the pump and forward/direct drums back together it’s...
-
-
Matt69olds replied to the thread Strange square holes in case....Here is a brand new case cast by ATI for drag racing. You can see the hole in the same place.
-
-
Matt69olds replied to the thread Strange square holes in case....Crap, I forgot to take the picture. If that’s the only concern, then go head with the overhaul. Lots of cases have holes cast into...
-
Matt69olds replied to the thread Strange square holes in case....That’s just a drain hole. They are cast that way. I have a th350 torn apart on my bench, I’ll take a pic when I get home from work.
-
Matt69olds replied to the thread Haynes manual suggest silicone dielectric grease for ignition module?.I’m pretty sure it’s mentioned in the factory manual to use thermal paste. I’m sure the book says to use GM part number whatever, but...
-
Matt69olds replied to the thread CUCV Torque Slip (TH400).I forgot about the diesel governor!! When I swapped the 455 Olds in place of the blown up 350 Olds diesel on the first test drive I...
-
Matt69olds replied to the thread CUCV Torque Slip (TH400).They will physically interchange, it’s the internal pump/turbine/stator combination that is the problem. The torque curve between a gas...
-
Matt69olds replied to the thread CUCV Torque Slip (TH400).Get a remanufactured converter for your truck with the gas engine. The stall speed will be all wrong for the engine, especially if the...
-
Matt69olds replied to the thread Haynes manual suggest silicone dielectric grease for ignition module?.Thermal paste is NOT dielectric grease! Dielectric grease is designed to seal connections from moisture, and to allow easy disassembly...
-
Matt69olds replied to the thread 700r4 problems.In theory it should go to first in fist gear and shift as you move the lever. I’ll be honest, I have never tried it in a 700. I have...
-
Matt69olds replied to the thread 700r4 problems.Will it back up? If not, I bet you will find it has no overdrive either. If you have no reverse, 2nd, or 4th, most likely the drive...
-
Matt69olds replied to the thread No brake, running, reverse nor tail lights! Help!.If I remember correctly, the taillight harness feed is the smallest of the connectors at the firewall electrical connector. Since you...
-
-
Loading…
-
Loading…
Latest posts
-
-
-
-
'88 GMC R3500 DUALLY W/350 TBI and idle closed loop problems.- Latest: GMC dirty glass
-