Not against pie cutting btw, I just did it to see how clean I could make the exhaust. After paint it looked amazing. Wish I took pics
Sent from my SAMSUNG-SM-G920A using Tapatalk
Well for the sake of lack of tools, this was ideal. It was a little time consuming due to needing the pipes cooled before test fitting but the whole thing came out perfect with a little patience and twerking.
Sent from my SAMSUNG-SM-G920A using Tapatalk
So I haven't really been following the post, but I watched this video on YouTube and I made my complete exhaust like this. I only had to make 2 welds for the whole thing (wanted as little piecing together as possible) but because I added an extra piece
Sent from my SAMSUNG-SM-G920A using...
Oh c'mon. I guarantee most guys on here that are married have budgets set for them all the time. If not, we'd spend all the money on beer and parts lol
So i think I'm going to buy a little flux core 130, do you think that would be sufficient if I played the back and boxed the frame? I don't plan on towing much honestly but I just want it to give when going down the road one day.
I apologize, didn't see the notification. I am running dual tanks but it doesn't switch to my passenger side. Every now and again my fuel pump on driver side will lose power, I'll have to crawl under and wiggle the connector then the pump starts working, even the gas gauge starts to work every...
I have this exact issue. So you're saying oink runs to tank but spiced off before tank is brown 30a and that leads to switch. You're saying eliminate 30a basically?
So would this wire running back mess with how the gauge works? Mines either completly horizontal on the full side or it bounces around. I think there's some loose wires or a poor ground because every now and again my fuel pump will lose power. The needle just recently started bouncing and work...
I watched a YouTube video of a guy doing his frame and he said that a pro from his home town said he like the horizontal cut more so I think I might go that direction. How many inches did you take out of the center? I think I remember him saying 12 and an additional 4 at the rear
Thank you for the tips, i really appreciate it. I used to be certified with 7018 in a few positions so I was going to go that route if I can find someone with the welder. Thought about Mig but I want guarantee that it'll hold up, plus my wife won't let me get a welder yet. Gotta love that...