Recent content by Long Rider
-
-
Can you dig it.
I am with that gentleman. I don't buy anything without an ashtray for the same reason. I have never smoked anything, but I don't like on board computers or sensors. The stuff with ashtrays I can mostly fix myself. As for my Square Body's, I usually install a cup holder where the ashtray was.- Long Rider
- Post #5
- Forum: Tech Discussion
-
-
New To Forum
Welcome aboard from the "RED NECK" side of Oregon. (eastern)- Long Rider
- Post #8
- Forum: Introduction
-
Hello everyone, I'm Walter; I'm new here.
Welcome aboard. That is a very nice looking "Burb"- Long Rider
- Post #19
- Forum: Introduction
-
New Grumpy Guy
A sweet ride and welcome aboard. You are now an official Square Body addict and there is no 12 step program. Enjoy the ride- Long Rider
- Post #14
- Forum: Introduction
-
Thinking about a new smaller steering wheel, comfort grip or forever sharp?
I find myself kinda tight against the stock wheel, so I went with this from LMC. 14 inch.- Long Rider
- Post #27
- Forum: Interior
-
-
-
New Badges for Military Service Members, LEO, FireFighters and EMT
just another to be expected GREAT idea. I am a retired Marine grunt, former deputy Sheriff- Long Rider
- Post #32
- Forum: Site News
-
Hello all.
Welcome aboard. There is no 12 step program for Square Body addiction.- Long Rider
- Post #20
- Forum: Introduction
-
-
LED bulbs in gauge cluster
Try to find quality parts. I went with a new circuit board, an inexpensive one and two of the bulbs were getting 0 volts. I couldn't see anything wrong with it, they just didn't get any voltage. I ended up getting board from LMC for a little more money but now all of my lights in my dash work.- Long Rider
- Post #17
- Forum: Gauge, Speedo & Instrumentation
-
New guy with his first square body
Welcome from Eastern Oregon- Long Rider
- Post #16
- Forum: Introduction
-
Wheel spacer question
I found that when I put 2 inch spacers on the rear of my 77 GMC 1500, I had to put new longer studs in at the same time or I didn't have enough thread to get the lug nuts even with the end of the lug. Almost half of the lug nut wasn't even on the threads.- Long Rider
- Post #10
- Forum: Differential & Driveline
