legopnuematic's latest activity
-
legopnuematic replied to the thread A/C stops blowing when I come to a stop??.If the blower motor stops/is intermittent, first thing I’d check is the heavy power wire going to the blower motor. The molded connector... -
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with
Like.
I didn't realize it till I was cleaned up and about to leave, I also needed to cut the light saber thing down a bit too. I'll do that... -
legopnuematic replied to the thread Drivers door will not unlock all the sudden..Have you tried pushing the button on the exterior door handle first, then attempt to unlock? My 76 is that way. Don’t know why...
-
This old system doesn't use any pressure switches, it's all controlled with the expansion valve and POA valve working in tandem. The...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Then I moved onto the Buick Rendevous AC knobs. You can see my original knob on the left, it's shaft retainer hole is a good bit smaller...
-
legopnuematic reacted to Ricko1966's post in the thread Here’s the best heavy rust dissolver for smaller parts like nuts and bolts that you’re probably not aware of and is probably in your kitchen. with Like.
Citric acid works better than vinegar. Used in canning and soda pop etc. But you can buy it cheap online I just buy it at Walmart. Do...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Overall though, it came out looking great. I didn't clear the grey in case I didn't like it and wanted to redo it, so it's a little...
-
Some edelbrocks are for squarebore and spreadbore others are not,research your particular manifold.
-
You can’t get more reliable than a properly rebuilt Q-Jet. And unless your willing to spend some time tuning, i seriously doubt you...
-
legopnuematic reacted to Old77's post in the thread Old77’s GMT400 SWB 4x4 5-speed project/DD with Like.
Very good info! Thank you, Spencer! I'll definitely check it out regardless of the outcome of this project. I don't normally do a lot of...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Once the primer dried, I laid on some paint. I'd read that Ford Dark Shadow Gray is a pretty darn close match so I grabbed some of that...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
They're super easy to change, just release the 3 tabs on each side and it comes out the bottom Also swapped in my Esky interior...
-
legopnuematic replied to the thread Old77’s GMT400 SWB 4x4 5-speed project/DD.I’m kind of suspicious of those DeWalt bits, I’m not really seeing anything that says they are really high speed cobalt. These are a...
-
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
Plastic welding is much more difficult than I thought it would be. Especially in that small opening. I ended up melting the back edge of...
-
legopnuematic reacted to TotalyHucked's post in the thread Huck's daily - 2005 Z71 crewcab with Like.
There was still a bit of hazing after the last couple coats since they were sprayed out in the humidity, so I was worried about the...
