-
-
KnuckleBuster replied to the thread Need a starter heat shield....Well, it turns out that it was the wrong one and wouldn't fit (thanks anyway, 74Blaze!). So, I still need a shield or 2. -
KnuckleBuster replied to the thread Need a starter heat shield....Ok. That's one possible. Anyone else?
-
I'm looking for a starter heat shield for a 1991 C1500 4.3L. The original part number was 10468258, but it was discontinued long ago. It...
-
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.I can't believe we're still on this. I only meant to clarify what I said. Didn't need research with photos and more 'expert' comments...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.Just to be clear, I NEVER said to whack the tank with a rubber mallet. Hand slap only. It doesn't take much.
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.Nope, I was referring to a side tank, specifically the left side. I don't recall where the connector(s) was on a dual tank setup. When I...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.I detect a note of sarcasm there, Ricko1966. Lol. Believe this: If I were losing fuel pump sales because I slapped tanks to get them...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.They might go away (their option, of course), but I doubt most would. But how often is a customer standing there when you're diagnosing...
-
KnuckleBuster replied to the thread Hard Start when engine is warm..So you have some mods to the fuel system. What kind of fuel line do you have? I had a truck once that had the same exact problem. It had...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.The connector for the tank unit. It should be accessible through the LR wheel well. The connector and the ground are attached to the top...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.I think you're barking up the wrong tree trying to check ALDL circuits. Except for checking for trouble codes, you can pretty much...
-
KnuckleBuster replied to the thread 1987 Silverado fuel issue.When you initially turn the key to the run position the ECM will only power the relay for 2 seconds and then will shut off. To power it...
-
KnuckleBuster reacted to Turbo4whl's post in the thread What are your favorite/ best looking valve covers for SBC? with
Like.
I have a set of these I was running on the turbo 305. Got them discounted from the local speed shop. You can still buy them from Summit... -
KnuckleBuster replied to the thread What are your favorite/ best looking valve covers for SBC?.When I saw the thread title I immediately thought of these and wished I had a pic of a motor I used them on some years ago. Kinda...
-
KnuckleBuster replied to the thread What should I sell engine & tranny for?.If you're ok with $500 then give him a try. The worst thing that can happen is he may say 'no'. I'm guessing he'll counteroffer. Ya...
-
-
Loading…
-
Loading…
