-
-
Cheepest one I've found. My neighbor has one and it's the cat's meow. https://www.amazon.com/dp/B0851C6Q22/ -
Juggernaut replied to the thread How should I solve this starter problem.The starter has the highest amp draw of anything on your truck. IMO you should be running your ground directly to the engine block, then...
-
Juggernaut reacted to Snoots's post in the thread How should I solve this starter problem with
Like.
-
Hey all, I have a 1978 K10 step side. Slowly restoring as money allows. So far interior has been done, new motor recently installed and...
-
Juggernaut replied to the thread 10SI Alternator rebuild.Great write up! One thing I can add for those who do a lot of 4 wheeling is to spray the windings with red insulating varnish. You can...
-
You spelled it wrong too. I call them Super Doodys…lol
-
Juggernaut reacted to Nasty-LSX's post in the thread Look at these 2 steering gear boxes. Whats best. with Like.
Trust me LOL, If your following me you know I make videos about everything and post them here with the LS swapped step side. A video of...
-
Juggernaut replied to the thread 3/4-Ton 2wd Rear Spring Replacement: Advice?.Be prepared to have to cut the front spring hanger bolts. Being you're in the rust belt with me, the bolt likes to rust to the bushing...
-
Juggernaut reacted to CalSgt's post in the thread WANTED: Automatic Pwr. Brake Pedal Assy. with Like.
FWIW: Removing the pedal mounting bracket is a bigger job than some assume. For starters it requires removal of the steering column...
-
Juggernaut replied to the thread Look at these 2 steering gear boxes. Whats best..Whatever box you go with, I hope you report back on how it feels. I would love to know if it actually gets rid of the inch or so play...
-
Juggernaut replied to the thread Look at these 2 steering gear boxes. Whats best..Wow, for those prices I'm glad I just rebuild them myself. Rebuild kit is about $30
-
Juggernaut replied to the thread Can you run Schaeffer 50W oil in a SM465?.When I had my SM465 rebuilt for the first time in the early 90's the builder told me to us SAE 50 ND. He told me the non detergent oil...
-
Juggernaut reacted to Snoots's post in the thread Haynes manual suggest silicone dielectric grease for ignition module? with Like.
NO, NO, NO!!! Like @gmbellew said; you need a thermal paste, sometimes referred to as 'heat sink grease'. Get a genuine GM module. DO...
-
I'm not sure what the gripe is here. We were all interested in talking about it... but it just wasn't what you wanted to hear. What you...
-
Juggernaut reacted to Radiohead's post in the thread Removing Pilot Bearing//Is it as bad as I hear? with Like.
If you can't get a small puller (SnapOn etc has those) in there, find a shaft that is similar to the diameter of the input shaft. Pack a...
-
-
Loading…
-
Loading…
