Quadrajet Dual Capacity Accelerator Pump Switch on my carb needs wired. So I have no carb accelerator pump sensor switch on my 1985 K10 305ci. I don't even know what it looks like. There is 2 plugged ports on my thermostat housing could that be where it goes?. Can anyone show me what one...
A friend mentioned to me that the original Catalytic Converter may be bad on my truck. He suggested I should just have then local muffler shop weld a bypass pipe on instead of replacing it. I know the previous owner removed and bypass the emissions on the 305ci engine when they put a new long...
Worked today on the TV cable again. Every time I adjust it it comes out the same. When I thought back I realize that I connected the TCC fire wall valve back up to vacuum as I described in another thread and thats when no downshift started. I disconnected vacuum and the trans up shifts...
Well I get no downshift at all. The normal acceleration is smooth and seems to be totally correct. I also re-hooked up the TCC valve on fire wall. No sure that has anything to do with the downshifting...
M
The TV attachment point is 1 1/8 inch from carb butterfly shaft but maybe slightly back and not straight up and down. I printed out the deg measurements on paper and the movement looked correct as depicted in drawing.
Fingers crossed that it shifts as it should now.
Wasn't sure if this is called geometry, but made sure that the connection to carb was close to these measurements in degrees. I have the same line drawing.
thanks
So I read the service manual I found on this site. Great Job BTW!!
The TV cable operates very smoothly and does not bind or stick. So I adjusted the cable so that idle position is where the TV cable starts and pulls back to on its own and at WOT is the max position it extends. At WOT it is...
Wow I guess I am lost. The cable is loose at idle and can't go any tighter at WOT. How would a different cable change that? I was thinking it was the linkage on carb that could be wrong. The TV cable being further away from pivot point would change indexing.
Thanks for the reply...
M