iamtherealJayy

Latest activity Postings About

    • iamtherealJayy
      iamtherealJayy replied to the thread Slave cylinder problems.
      This may be an obvious thing but is it possible to “over bleed” a hydraulic system? Could there be too much fluid in it and it’s...
    • iamtherealJayy
      iamtherealJayy replied to the thread Slave cylinder problems.
      How can I tell if it’s extending farther than it should? And how could I fix that?
    • iamtherealJayy
      iamtherealJayy replied to the thread Slave cylinder problems.
      The previous owner(my dad) replaced it as well when he had it and said the older fellow before him had it replaced several times as...
    • iamtherealJayy
      iamtherealJayy replied to the thread Slave cylinder problems.
      It starts to bog down the engine yes, as far as I can tell the clutch system is bled as well as I can. The first time took me several...
    • iamtherealJayy
      1987 Chevrolet V20 with an SM465 I believe, L123R gears, it’s got hydraulic clutch and I’ve replaced the slave cylinder twice in the...
    • iamtherealJayy
      iamtherealJayy replied to the thread Dome light issue.
      I have the door jamb switches on the way to replace them, can’t hurt anything, and I’ll check the wires and see if something is...
    • iamtherealJayy
      Edelbrock is easier to take off than q-jet I figure, I’ll take it off I just didn’t want fuel to leak all over intake manifold
    • iamtherealJayy
      iamtherealJayy replied to the thread Dome light issue.
      I have new door jamb switches and headlight dimmer switch on the way, I figure can’t hurt to replace them, and the dimmer switch was...
    • iamtherealJayy
      My biggest problem is small pieces, I don’t want to drop something down the intake. If all the small pieces are on the outside I’ll do...
    • iamtherealJayy
      Calibration kit on the way! Is it easier to do the swap off vehicle or can I change it on the vehicle? I know metering rods and springs...
    • iamtherealJayy
      Since I doubt my response on other thread will be seen, Little late here but I’ve got an 87 v20 and the other day I came out and my...
    • iamtherealJayy
      iamtherealJayy replied to the thread Dome light stays on.
      Little late here but I’ve got an 87 v20 and the other day I came out and my battery was dead, noticed my some light wouldn’t go out when...
    • iamtherealJayy
      Are the jets/rods obvious what size they are? So I can see what size current ones are? And know what size I’m putting in? I’m going to...
    • iamtherealJayy
      Can you explain the two steps down? I’m looking at the chart of rods/jets and which combo should I go to? Would #24 be the correct...
      • 3C87F80E-D7C7-458F-BAA5-4E5642C5953C.png
      • 3CF6B544-3A7C-4B4D-8D2A-79DF50767E6A.png
    • iamtherealJayy
      I reckon I’m going to look into a fuel pressure regulator since mechanical fuel pumps are notorious for delivering too much pressure...
  • Loading…
  • Loading…

Latest posts

Forum statistics

Threads
34,482
Posts
719,955
Members
22,894
Latest member
Hotrod5220
Top