-
-
HYou DO need to replace the Receiver/Dryer!
-
Hhdchevy replied to the thread New to the Forum.Welcome!
-
HHello, I just recently purchased a 1985 C10 stepside. I have restored many trucks and cars in the past. Now that I’m retired from the...
-
Hhdchevy reacted to NickTransmissions's post in the thread 350 TRANSMISSION SPEEDOMETER GEAR HOUSING with
Like.
Pull off the extension housing then remove it from the inside. -
HNewbie here. I've owned this truck for 32 years, sold it and just bought it back. 454 4 speed granny 3/4 ton
-
HWhat is your intended use for the booth? A booth won’t necessarily make or break a paint job, lots of very good work has been done...
-
HI’ve seen other cars where the markers alternate like the squares, so there may be a bulb design that works. However, if the old style...
-
HYep front lights are wired funny on squares and you will have issues on front turn signals and markers because they won't always be...
-
HThat's a slight bit higher than most SB I have seen but not high enough to worry about. After all, it's not a Chrysler that blows oil...
-
Hhdchevy reacted to DoubleDingo's post in the thread High oil pressure after replacing pump with Like.
Sounds like normal oil pressure to me. If you had worn main and rod bearings it may be lower, but I wouldn't sweat the numbers you're...
-
HSounds just right. Although previous pump was also fine at those pressures.
-
Hhdchevy reacted to legopnuematic's post in the thread High oil pressure after replacing pump with Like.
I wouldn’t be worried about that at all.
-
Hhdchevy reacted to mtbadbob's post in the thread Removing instrument panel - dealing with the oil pressure line with Like.
Yeah, me also. I believe it's a 3/8" nut, possibly a 5/16"
-
Hhdchevy replied to the thread Removing instrument panel - dealing with the oil pressure line.The smaller in length the better for behind the instrument cluster. I have always disconnected from behind. I'm sure disconnecting from...
-
-
Loading…
-
Loading…
