I made them. My blazer didn't come with the fold and tumble rear seat. I didn't feel like cutting into the floor board and finding the cups that fit into the hole. So I made these. The seat sits a little higher but unless you're 6'4 or taller you don't have to worry about it. Here is a picture...
Spend some time fixing both center bolts on rear springs.
Notice the leaf spring that is almost out. I'm also missing my pinion angle shim.
I also had a buddy replace the broken rear gears. I guess I should go a little easier or upgrade to a 14 bolt.
I have no idea where the rest of that truck is but an 8 foot stepside bed was never very attractive anyhow. It makes for a great utility trailer though. Sorry I haven't been around much. I've been extremely busy with work and home. It seems that the company I work for would rather dump tons of...
HELL YEAH!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!!! Go St. Louis Rams!!
Go Fresno State Bulldogs!! With first year sophomore starting QB Derek Carr! He is the brother to current NFL QB David Carr! First up is the Cal Bears! PAC 12 sucks! Ha-ha!
I need tires for my K5 too and I would put them on my K5 but they don't have the right size. I would consider the 35 inch tires they have if they were wider than 12.5. I'm looking for 36 or 35 inch tires in a 14.5 wide or around there.
They are not "raise" red letters so I think I will be OK unless the red is not "UV" protected in which case the red fading to pink with get them switched around to black walls in a hurry, haha.
I was playing blackjack. I sat down at a blackjack table in old downtown Las Vegas and turned $100...
I hope it will be ten times better than my K5 but that is just a dream at this point. I guarantee there will be no corner cut on this project, that is for sure.