fast 99's latest activity
-
fast 99 replied to the thread dies at low idle speeds, when put into gear and when stopped..Some of the early Ford OBD1 stuff didn't have a scanable data stream, I agree. GM TBI is a simple system fairly easy to diagnose. -
fast 99 replied to the thread dies at low idle speeds, when put into gear and when stopped..Yes hard to diagnose with little information. When did this start? A good inspection for tune up related items, plugs, timing, could...
-
fast 99 replied to the thread How many freeze plugs on a 350 SBC?.Will add most 2 bolt mains were 2 soft plugs per side, 4 bolt mains were 3. Back in my racing days we cheated rules by using a 2 bolt...
-
fast 99 replied to the thread Rochester Quadrajet issue.When choke is completely warmed fast idle on right side shouldn't change idle speed. Either choke isn't warmed enough [no preheat], bad...
-
fast 99 replied to the thread Oil Sample low Viscosity.200k is a lot of miles. Could just be leaking by the rings. Perform a leak down.
-
I hate to just replace O2 sensors without testing them. But 35+ year O2 sensor,just get new one. While your old one is out put a volt...
-
fast 99 replied to the thread 14 bolt brake cleanup.looks like it has already been in Hawaii.
-
fast 99 replied to the thread 14 bolt brake cleanup.Old shoes can cause all sorts of issues. Toss them out. Remove the hub, clean/buff spindle area replace seal. This is one place where...
-
Make a mark on the housing where the tight spot is,make another mark where the loose spot is. Pull the seal,measure the gap between the...
-
fast 99 replied to the thread Uneven rear main seal, help needed..That condition is real odd. Could the seal housing be bent? It's an aluminum piece, careless removal or dropping the engine could easily...
-
Okay in your pic 1 that black bolt head to the right of your crank that is a fixed point,it doesn't move. Now let's say that bolt head...
-
fast 99 replied to the thread E-brake sticking after rebuild.If emergency cables stick and don't return completely the self adjusters will take up, over adjust and wear the shoes out. This is one...
-
fast 99 replied to the thread E-brake sticking after rebuild.Crawl underneath and pull on the cables by hand. They should retract completely when released. I replace many cables when doing brake...
-
I like the small chain-link ones, they're easier to steer with handcuffs on.
