-
-
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.Thank you! Aside from the paint and body, I built it in a storage unit, so given those limitations and my own experience I certainly... -
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.Glad my experience helped at least one person. The actual length difference was closer to 1.5 inches, the Sierra trans being shorter...
-
Elliot W replied to the thread C10 LS swap questions (I maybe over thinking).Oo got it. There is the power terminal in the center of the firewall if you care to use it.
-
Elliot W replied to the thread C10 LS swap questions (I maybe over thinking).To use the stock gauges in the truck with the LS, I ran the existing wires to the LS. I bought a temp sensor adapter (can't remember the...
-
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.
-
-
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.Its a 66 2-door sedan. I've had it for 5 years now (as of yesterday) and learned a ton from working on it (floor pans, paint/body etc.)...
-
-
Elliot W replied to the thread Holley sniper install questions.Is the battery old? I thought normal crank voltage drop was between 10 and 11. If you think you might need a battery or more CCA, it...
-
Elliot W replied to the thread GMSB Forum T-shirt Available.Good question....I'd be interested in a shirt and sticker.
-
Elliot W replied to the thread Holley sniper install questions.I'm fairly certain that voltage drop while cranking is ok for the pink wire. The important one to not have voltage drop is the red wire...
-
Elliot W reacted to CalSgt's post in the thread Whats the going rate for shortening a driveshaft? I think I got....shafted with
Wow.
First time I needed a steel driveshaft shortened it was about $125-$150 with u-joints (in 1998) Last time I had the same rear shaft... -
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.I got the shaft shortened to 60 inches joint to joint. I suspect it was about 65 inches or more when I got it. I think it came off a 90s...
-
Elliot W replied to the thread Whats the going rate for shortening a driveshaft? I think I got....shafted.Thanks all for the input. Turns out I'm probably just cheap and too committed to making this budget build as minimal as possible.
-
Elliot W posted the thread Whats the going rate for shortening a driveshaft? I think I got....shafted in Differential & Driveline.WARNING: Partial Rant I'm putting together an LS with a 5 speed trans (NV3500) 2WD in a SWB. The truck did not come with a...
-
-
Elliot W replied to the thread New motor... from 250 to 350.If you are sticking with a sbc (non LS) in the future and on a budget, I'd recommend staying with a 3 speed or 4 speed (you'd save...
-
There are alot if threads about it. Here's my opinion on it if you are on a budget or not. Front: 2.5" spindles doesn't really matter...
-
-
Loading…
-
Loading…
Latest posts
-
Goodwrench crate engine smoking from passenger side exhaust- Latest: iamtherealJayy
-
-
-
