Recent content by Dixie Pride

  1. D

    Emissions question

    In Maryland say 30yrs. ago i took off my cat.converter in did not pass.So i went to Motor vehicle admin. and registered my truck as a 10.000 gvw which made it exempt from emissions inspection.I also put farm tags on it so it was exempt from a bumper height law we have here.Boughth her new in...
  2. D

    Need to replace rubber fuel lines on top of both tanks….

    1985 K20 I forgot i used my tractor with a log boom and 4 straps to take the bed of and back on it was a little trickey but made it work, dont forget to unhook the electric, taillight brake line clips .
  3. D

    Need to replace rubber fuel lines on top of both tanks….

    1985 K20 had since new.While i had the bed off i replaced my dual tanks and soft and hard hoses.Bed bolts can be hard to get off they are more like a carrage bolt.Tank strap bolts can be tought too.I did float replaement while i had the tanks out.Sometimes the easest jub can be a bitch.Dual...
  4. D

    Big block running hot. Can’t figure out the issue

    I have had an 85 3/4 ton since new has a 350 motor.Mine was runnning a little hot ,flushed the radiator twice and put a new GM Radiator cap and it helped a lot.
  5. D

    Driveshaft too short after lift?

    Have a 1985 3/4 ton longbed with a 5" front lift for 40 years,it has been airborn before and no issues.Most folks agree if you see no spline you are ok .
  6. D

    Power steering too slow?

    Mine had a lot of slop in the steering Changed the power steering fluid and it made a world of difference. Hate to admit it but i have had my K20 for 40 years and i never changed the Power steering fluid only added to it all those years.
  7. D

    2.5" or 4" Lift 1986 K10

    Sorry i dont own a cell phone to take and attach pictures. My K 20 wlll be 40 years next month .4" spring lift in rear 5 1/4" in front,3" body lift with 44x18.5 mudders. The reason the tires fit was i put bushwaker CUTOUT fender flaires that made a world of diference for clearance.4" drop...
  8. D

    Lift kit

    DIXIE PRIDE 85 K20 longbed manuall tranny Sorry i for forgot to say 4" rear Blocks,new 4" arch front springs with 1 1/4 " steel blocks pinned and welded to give the truck a little rake.3 inch body lift and cutout fender flaires. So the cutouts make a huge difference while running 44" mudders on...
  9. D

    Lift kit

    1985 K20 4x4 manual longbed.When i restored my truck i went on the cheap with rough country 4" front springs & 4" blocks in rear,3" body lift I had already i pinned and welded 1 3/8" steel blocks to the front axle pad to give it a little rake. I know they say you should not block the front but i...
  10. D

    Smog thoughts

    Had a shop do my 1985 K20 4x4. No big deal to the them.Removed the smog pumps,hoses and plugged the engine and i took that nasty converter off.Really cleaned up and simplified my 350 motor. In my mind i want to say it runs better but other folks will say it does not make a difference. In MD. i...
  11. D

    Thoughts on going down to 37s?

    Had my 85 K 20 since new 2 sets of 40" 1 set of 42". Was never happy always wanted 44"swampers. Saved & got my 44" after 39 years.it is always what make you happy.If you want them bad enough you will find a way.My Swampers were $639.00 ea 2 years ago now they are almost $1,000 ea.Ig you go with...
  12. D

    Pulling all the smog stuff

    My 85 K20 350 engine is not fuel injected.I had a shop de-smog mine. I had taken the converter off years and went to dual exaust.The shop removed the smog pump and everthing it went to.There is one place in the engine that has to be plugged.My engine looks clean now runs better in my mind than...
  13. D

    2 or 4 inch lift kit

    Did my 85K20 with an 8 foot bed 39 years ago with 4" blocks in rear 4" leaf springs in front with 1.5 blocks,pinned and welded to give it a negative rake in front.No drive shaft mods and only changed my universal joints twice in all the years 66K miles on it I also have 3" body lift & cutout...
  14. D

    Should this new guy buy this '85?

    Bought my 85 K20 new.Sat for 12 yrs finally 2 yrs later got it running again.Stuff like rear drum brakes gas tanks slave cylinder gas and brake lines wheel bearing & seals.Took the bed off replaced the cross members,rocker panel and floor board patch 6K later ,looks great.Yours or the one you...
  15. D

    Do I need different gears with 33” tires and 4” lift

    My 85 K20 manual has 44 swampers on it with stock gears.It is just a 3 speed now i guess ,dont go over 40 mph anyway.It is just a wax and make a beer run on Sunday truck.Had it since new and it never gets dirty anymore.Name on the side of the truck is Reverent Black. Sure love my truck it stays...
See more

Latest posts

Forum statistics

Threads
45,570
Posts
986,490
Members
38,661
Latest member
Todd Lemon
Top