Recent content by Dads84
-
side trim moldings
It's coming loose at the very edge on two pieces, the ones on back wheel well , behind the wheel. I think if I clean with Q-tip, using alcohol, I might get lucky and it will stick better. -
Tailgate trunnions
I have a older tailgate on my 84. the tailgate came from a 74 ( like the Chevrolet letters that go all the way across the tailgate) the trunnions are different. the older ones have a larger circumference then the newer ones. The parts store only had the smaller ones, and that would set my...- Dads84
- Post #2
- Forum: Tech Discussion
-
side trim moldings
I bought LMC's , pre cut , side trim moldings. I cleaned the area where they would go with, wax and grease remover, then with brake cleaner, let it set of 10 min, and attached the trim. The trim keeps coming loose, WHY? I push it back down and a few days later it is loose again. Any advise? -
running boards, nerf bars, step bars !!!
I have seen the hoop steps, but I don't want to put holes in my rockers for them. Looking for something that mounts to frame, or body mounts.- Dads84
- Post #10
- Forum: Aftermarket Accessories
-
running boards, nerf bars, step bars !!!
I'm sure this has been talked to death, but I would like to add step bars to my 84 chevy k10 ( i'm getting older, and heavier ) hard to get into my truck. would like bars that attach to front cab mount , and rear spring mount, because of outside mounted gas tank. Anyone have this set up on there...- Dads84
- Thread
- Replies: 47
- Forum: Aftermarket Accessories
-
tail light connector what does this go to???
Fixed the side marker lights. just needed new bulbs- Dads84
- Post #5
- Forum: Electrical & Audio
-
tail light connector what does this go to???
That is it ! Thanks, I don't have tailgate lights. So I don't need them. Now to find out why my side markers don't work back there.- Dads84
- Post #4
- Forum: Electrical & Audio
-
tail light connector what does this go to???
Need help, all lights work in back of my truck, except the rear side markers. does this connect to them? there is no plug- in for this to hook into. I thought license plate light, but they work!- Dads84
- Thread
- Replies: 4
- Forum: Electrical & Audio
-
-
Grille inserts?
Is it a vinyl tape? how has it held up on your truck? how long has it been on your truck. Where did you buy yours- Dads84
- Post #7
- Forum: Paint and Body
-
Grille inserts?
any idea how to remove the tape. it will not pull off. paint remover? thinner? I think I will go out and try a heat gun.- Dads84
- Post #3
- Forum: Paint and Body
-
Grille inserts?
I don't know what they are called, but I'm going with grille inserts. Has anyone tried to paint these ? Looks like some type of tape, now days it's called rap. can I paint over the tape .I know it's chrome ( stainless) under it, do I need to remove tape, and scuff chrome to paint, so it will...- Dads84
- Thread
- Replies: 26
- Forum: Paint and Body
-
carmine headliner
Thanks, I checked , and it is carmine, so I will order from them, although shipping is high, from there to Indiana. -
carmine headliner
I'm going to order a headliner for my truck. LMC has a red headliner, I want a Carmine red headliner ( match dash and all trim ) how far off is red vs carmine red ? has anyone seen them side by side ? Thanks for the help. -
1984 Headliner
My truck did not have a headliner from the factory, but my parts truck did, they have same color interior , and all the plastic trim is perfect. I do need to replace the headliner. So I'm getting ready to order the headliner. In the parts catalog, it has two options, one is for factory...
