CalSgt's latest activity
-
CCalSgt replied to the thread Find the short in brake light?.I just snip the wires at the switch before I remove the busted one and use them to pull the new wires through the column... ETA: @Grit...
-
CThe yellow wire from the tail/brake lights go through the Turn signal switch in the steering column. My specific problem was that with...
-
CCalSgt replied to the thread 77 big10 roller 5.3 LS swap.Prepare a plan for the fuel system which can be a costly addition to the EFI swap. You’ll need a tank (or tanks) for an ‘87 with the...
-
CCalSgt replied to the thread Bare Standard Cab Actual Weight.There’s not really an inner structure to the latch pin so I don’t think I’d use it, the hinges do have some heavy sheet metal and an...
-
CCalSgt replied to the thread Bare Standard Cab Actual Weight.Could probably be done with 4 strong dudes... I'd guess it only weighs a few hundred pounds You can add an easy handle to the rear by...
-
CPut a piece of gutter with end caps behind the seat.
-
CCancel the rough country order and get some softer springs so that you're not caller #69 in 2 weeks asking us if theres a way to make...
-
CCalSgt reacted to Ricko1966's post in the thread Stock Cold air intake performance upgrades with
Like.
You aren't going to get enough of a ram air effect to benefit you. The guys doing this for real are less than 1 percent gains on 10... -
CCalSgt replied to the thread Stock Cold air intake performance upgrades.Maybe with a higher HP SBC some additional cool air would benefit, but I’d gamble if there was HP left on the table due to the intake...
-
CCalSgt replied to the thread Bell housing / transfer case bolts.I guess it’s possible the LS trucks used a different method to support the bottom of the bell housing. I’m not familiar enough with the...
-
CCalSgt replied to the thread Bell housing / transfer case bolts.Best I can do is a screenshot from a video from under my chassis. Looks like your bell housing is a little different than this one but...
-
-
CCalSgt replied to the thread Bell housing / transfer case bolts.On SBC I believe these two holes had rods that went forward and bolted to the motor mounts. Not sure what the LS trucks had. I...
-
-
CCalSgt replied to the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ?.Not sure the exact length but 700R4/208 front shaft would be longer too 208 uses round flange mount
-
CCalSgt reacted to Ricko1966's post in the thread Front driveshaft - longer on a NP203 vs NP205 ? Same mount ? with Like.
You should have capitalized underlined and quoted" I AM NOT CHANGING TRANSFER CASES" You'll know better next time.
-
CCalSgt replied to the thread 84 K10 full exhaust replacement.lol, it will be a job pulling that big iron 4 Speed no matter what exhaust is on it
