cadillac_al's latest activity
-
Ccadillac_al reacted to Toad455's post in the thread Another leaf spring question: (plastic shims). with
Like.
Well, I dug around more and found a site "General Spring". Search "leaf springs", then "leaf spring parts", then "tip inserts"... -
Ccadillac_al replied to the thread Overheating 87 TBI.How long have you owned this truck? I am going through an overheat issue with my truck. The fan clutch failed and it would over heat...
-
Ccadillac_al replied to the thread Polishing up the gauge lens.I just love seeing that 74 olive green. One of my trucks is getting painted that color next time I paint one. I need to polish my...
-
Ccadillac_al replied to the thread BBC 396 wil not idle with any carb.Is that an HEI ignition or points?
-
Ccadillac_al replied to the thread Update on my Ignition Module failure!.I was lucky to buy a few $50 Skip White distributors before he quit selling them. They are over 10 years old now and still work great...
-
CThanks everyone, I will leave as is
-
CThe other thing to consider is that it is likely that the sway bar is binding up and greatly stiffening up your ride. The sway bar...
-
CI wanted to post a quick update on my 1986 K10 lift kit and hopefully it will help someone make a decision if they are looking for a...
-
CI once had a TH350 with a harsh 1-2 shift after I installed a B&M "Shift Improver" (ha!) kit. I called TransGo and their guy told me...
-
Ccadillac_al reacted to KeithM's post in the thread Turbo350 w/shift kit slamming 2nd gear with Like.
Well Bingo! I took the spring out of my old trans and when I popped the cover off the new one I found a spring that was cut off an inch...
-
Ccadillac_al reacted to luna negra's post in the thread Exhaust pipe kits from @mazon/ eBay with Like.
I've had good luck with the pre-bent kits from Summit. Just a little bit more than the DIY and the bends were spot on...
-
CI would have a real tire guy put a patch on the inside and glue the outside with that vulcanising glue they have. Also keep track of...
-
CI drain the master cylinder before I do a brake job with a turkey baster or a Mighty Vac, clean it out as best as possible and refill...
-
CI got mine from a local GMC dealer in 2006 "just in case" the old one had a problem. Looks like this part is still available at not...
-
CReplaced that proportioning valve and bought a fancy vacuum bleeder, which worked quite well except for one thing. As it pulls the fluid...
