Bloodhound1981's latest activity
-
BBloodhound1981 replied to the thread LWB driveshaft question.I have a 1981 C10 longbed with a factory one piece driveshaft. I replaced it with a 5" aluminum. The weight difference is unbelievable.
-
-
BDo you not remember finding a ground strap between the bed and the frame when you pulled the old one? Yes, you need a ground strap from...
-
BJust replacing a braided ground strap with a large gauge cable may or may not give you a "better" ground. The braided strap from the...
-
BBloodhound1981 reacted to aasleson's post in the thread What have you done to your square lately?? with
Like.
Finally found a set of 31x10.5x15's and even came with a decent set of rims, we'll see how the paint holds up but they were $600 and the... -
BBloodhound1981 reacted to Camar068's post in the thread What have you done to your square lately?? with Like.
put a street demon on the 350 long time ago before the LS swap. Was happy with it.
-
BBloodhound1981 reacted to Camar068's post in the thread What have you done to your square lately?? with Like.
lubed up the window tracks. So much easier to crank them down.
-
BMade my own using universal ac condenser brackets off Amazon. I wish my stock top cover would of worked but it won’t anymore
-
BBloodhound1981 reacted to cookster's post in the thread 77 K-10 Silverado Suburban in Tuxedo Black with Love.
Well, I got this over the weekend and drove it about and literally got a thumbs up from everyone I drove past in my rural Northern Utah...
-
BLol yep, gotta buy some new springs. If it's got a small block in it, get the Moog replacement big block springs. Cut 1 coil off (1 coil...
-
BGet some 2.5" drop spindles and go back to stock springs.
-
BI’ve been lurking on this forum for a couple of months and found it to be awesome for us folks with old Squarebodies. Have had a ‘73 C10...
-
BI went round and round with this very same issue on my 1987 V10 when I first got it. From the look of the remains of the TCC plug...
-
BI’ve been looking the past few years for a suitable daily driver. I’ve seen plenty of rust buckets but finally found a no-rust AZ truck...
-
BBloodhound1981 reacted to Tank6x2's post in the thread What have you done to your square lately?? with Like.
Took the weekend and installed Design Engineering Inc cut and form transmission tunnel heat shield, managed it two pieces and heat tape...
-
BBloodhound1981 reacted to DoubleDingo's post in the thread What have you done to your square lately?? with Like.
For some reason me and the bugs have an understanding, I leave them alone if they leave me alone. Haven't had wasp nests in decades yet...
