Bennyt's latest activity
-
BInstall the brackets on the bumper, leaving the hardware barely hand tight, then slide the bumper onto the frame rails and use jack...
-
BBennyt replied to the thread K5 rear seat just wont latch!.10mm socket?
-
BBennyt replied to the thread Full 1980 square headlight set up..Assuming you are happy with the quality, can you let me know who did them for you? I need 2-3 sets done for 73-79.
-
BIdk…. I paid close to $800 just to get my 1980 bezels chrome plated since all that is available in the aftermarket is chromed plastic bezels
-
BBennyt replied to the thread I think a rod spun a bearing in my rebuilt 454.Why are the outer main bolts not installed?
-
BBennyt replied to the thread I think a rod spun a bearing in my rebuilt 454.I think Ricko and some others are giving some solid advice and I'd definitely stick with what you already have. If it's a true...
-
BBennyt replied to the thread 73-87 Rear Disc Brake Conversion Problem.Yes, they can be mounted upside down and I have done that purposely on my own truck. It allows you to run the p-brake cable over the...
-
BBennyt replied to the thread 73-87 Rear Disc Brake Conversion Problem.This! Ratcheting the p-brake is a must
-
BBennyt reacted to Ricko1966's post in the thread 73-87 Rear Disc Brake Conversion Problem with
Like.
What is the piston diameter in your stock calipers and your eldorado calipers. Was your master designed for a 4 wheel disc. Or 2 wheel... -
BBennyt replied to the thread 1974 NOS doors..Only NOS once and I can conceivably see someone paying $750. After that, reworking a good used or aftermarket would be a better off as...
-
BBennyt replied to the thread Sear's Craftsman Handi Cut Cutter.I have one. Works well. Use it mainly for cutting hoses. Sold under several brands. Replacement blades available on Amazon.
-
BI've said it before and I'm sure I'll say it again. You sir, are a genius.
-
BBennyt replied to the thread 1" ORD body lift.The ORD zero-rate blocks are great. I installed a set on my K5. They have a lot more surface area on the cast part of the differential...
-
BOffset and width makes a huge difference in the arc that the wheel travels in. Look at my mower,sorry,couldn't stand one of my cars on...
-
BBennyt replied to the thread Suggestions for replacing this?.Ok, not in my shed. I have a few other bins to dig through. I can do that Tuesday. I also am about to install poly bushings on my C30...
