Once all the rust is repaired it will eventually be on air laying frame on 22’s. Body will be mainly stock looking without the trim and everything painted to match.
Yeah the 63 grille was pretty rough but the correct grille is actually near perfect just needs repainted. The hard part is going to be the floor. It needs a lot of work. Got to find a good deal on some repair panels. Like to get a whole floor but way too expensive
This one is all pretty stock except for the steering column. It seems to be from a square body. Guess they wanted a tilt column. It’s a hack job at best but got the job done at the time. They used all kinds of fun materials including a small piece of plywood, sheet metal roofing screws, and...
Been a while since I have been on here but thought I would share my new project. Picked up a 1966 Chevrolet C10 short wide. Came with a clean title and all the body panels. That’s about all I can say good about it. It’s covered in rust and dents but I got it cheap. I tore it down to the frame...
Yeah if it has factory disc brakes it is 6 lug. You would have to changes the front to 6 lug to match either by swapping spindles or buy using adapters.
Below Average Customs