ali_c20's latest activity
-
A couple pics on the trail up to Delilah Lookout in the Sequoia National Forest. And a couple more a little higher up in Sequoia... -
ali_c20 replied to the thread C20 to c10.The modular C20 spindles can be used with 5 lug rotors?
-
I’m trying to do this with as little work as possible, the c20 suspension is also in much better condition, I don’t see a reason to swap...
-
Hey, I recently bought a 1984 c20 off a friend to replace my rusted out 1974 c10, I would like to keep the wheels I have off the...
-
ali_c20 replied to the thread C20 to c10.You could swap all suspension, steering and brake components from your C10 to the C20 as the engine crossmembers and mounting points are...
-
ali_c20 replied to the thread Another newbie here....This: https://www.summitracing.com/parts/btc-trucknorris?srsltid=AfmBOoofILADWlgJC_oX9BlkjRnijmBKxGVRwsVFgXFVrqWEPXmQ38OM
-
ali_c20 replied to the thread Another newbie here....Welcome from Austria. Nice truck.
-
Here's a few pictures. Actually picking it up tomorrow.
-
ali_c20 replied to the thread 1981 Silverado.Welcome from Austria. Nice truck.
-
Been on here for awhile and realized I hadn't introduced my ride. Quite a long story but the short version is purchased last from the...
-
ali_c20 reacted to K5 Blazer's post in the thread 1973 Blazer tailgate aluminum panel restoration with
Like.
Did you have any luck on restoring your tailgate band? In the same situation with the same vehicle. -
ali_c20 replied to the thread 1973 Blazer tailgate aluminum panel restoration.The tailgate band of my K5 was completely shot, it had dents and holes from a spare tire carrier and other stuff. I made an aluminum...
-
-
Thanks for the warm welcome, everyone. The spacer blocks are kind of an experiment. I designed them in OnShape and printed them out on...
-
ali_c20 reacted to SquareRoot's post in the thread Cylinder head water passage corrosion, opinions? with Haha.
Personally, I'd Sh!tcan it and look for an LS. I mean you're already in it this far :shrug: Edit: Just kidding ;)
-
ali_c20 replied to the thread Cylinder head water passage corrosion, opinions?.IMO wipe it with some red Scotch Brite and run it.
