-
-
AKguy reacted to FireTruck1984's post in the thread Fender emblems without drilling holes? with
Like.
Use this stuff.. Works great, same as what’s used on new vehicles -
AKguy reacted to SirRobyn0's post in the thread Does anyone use Gear Venders unit with TH350? with Like.
I think it all depends on what a guy wants. Keep in mind the OP is debating TH350 W/gear vendors vs 700R4 not any of the other...
-
AKguy replied to the thread Valve Spring Question Mark IV 454.Call the folks at Comp, they will set you straight. They have always been very patient with me.
-
AKguy replied to the thread Patch Panel or Metal Fabrication ?.Yes, I have a MIG180 and a TIG225X, nice machines and great customer service.
-
AKguy replied to the thread No crank, no start.I had a similiar issue and found the battery feed entering the firewall side of the distribution/fuse block was loose. Looked fine until...
-
AKguy reacted to Big Ray's post in the thread Crew Cab Driveline(s) After Gear Vendors Installation with Like.
Just an FYI, i saw a GV unit for a NP203 on fleabay last night.
-
AKguy reacted to Bennyt's post in the thread Crew Cab Driveline(s) After Gear Vendors Installation with Like.
I'm planning on adding a GV unit as well and I was told same as above. 1 piece shaft. I am putting it behind a 700r4 in my 90 cc
-
AKguy replied to the thread Crew Cab Driveline(s) After Gear Vendors Installation.HMX-1?
-
AKguy reacted to MarineOne's post in the thread Crew Cab Driveline(s) After Gear Vendors Installation with Like.
A single aluminum shafy is what your going to want. Call or go to dennysdriveshaft.com those fellas make top tier driveline and can...
-
AKguy posted the thread Crew Cab Driveline(s) After Gear Vendors Installation in Differential & Driveline.I have planned a Gear Vendors OD installation on my 1980/81 K30 454/TH400/NP205/3.73’s Crew since I began the project. I sense the...
-
I’m currently running the gear vendors OD set up on my 82 C20, has factory 454 & turbo 400 trans with 4:10 rear gear & 33” tall rear...
-
-
Loading…
-
Loading…
