aasleson's latest activity
-
aasleson replied to the thread Sealing intake manifold?.R72232 is the John Deere part number, shows the balls themselves start off at .32 In. I can't remember off hand what they crush down though. -
aasleson replied to the thread Sealing intake manifold?.We use lead balls for figuring out shim packs for final drive preload on john deere tractors. If you have a deere dealer close I could...
-
aasleson reacted to WFarm's post in the thread What have you done to your square lately?? with
Like.
Finally got back around to the Blazer and finished up the bed rail caps. These were for 73-87 C/K trucks but the contours are correct... -
Bleh. pos truck hahahahahaha. I put the chassis harness on last night and scrubbed and scuffed the frame at all the ground points...
-
aasleson reacted to CoggedBelt75's post in the thread What have you done to your square lately?? with Like.
My glovebox has been sagging for a long time. Last Thursday, it finally gave up. Ordered a liner from LMC that night & it arrived...
-
I spaced my rack so the lower stock cup is right where the transmission hump/floor junction is flat. Then bolted the upper retaining...
-
Hello All, My dad bought a 1985 GMC Sierra Classic 4x4 brand new with power windows and even paid extra for a power rear window. He had...
-
I prefer to go old school, much cheaper:
-
Well I MAY have found an issue. I pulled the distributor, and connected the ground wire to the ground on the battery, positive wire to...
