I have an 87 gmc 4x4 1500 700 R4 tranny and also have a turbo 350.
The 700 lost reverse so I was wondering if I can bolt the 1975 turbo 350 right up or what I need to do so?
Thanks guys
got a guy that's gonna give me an estimate but if its that much I'm just gonna put another motor in for about
$500
When I get home today I'll smell antifreeze along with pulling out some sparkplugs. Thanks for the info
Yes it does have breather! Before i had I hooked up to the
Air cleaner but now just hanging with no
Restrictions.And still over heats.
Probably the head gasket!!
Hi Guys, I talked to a mechanic last night and seems to think its a head gasket!!
I replaced the fan clutch because it wasnt totally shot but close to it and also to see if it would help with the over heating. It did over heat before i replaced it
PCV valve is good
water pump seems to be...
Hi Guys,
I got an 87 gmc v1500 that was tbi and i switched to a carberator.
For the last few weeks the truck continues to over heat and is building to much
oil pressure that it will blow the rubber oil fill cap out and push the oil dipstick out some, and spray oil everywhere.
I replaced...
Hello
I got an 1987 gmc tbi 1500 pickup.
It cranks over really hard and after one try of cranking for about 6 sec the battery dosn't have enough juice to crank it over again!!! The battery is brand new and a good cold cranking amp.
Also it's an automatic and has bin making some noise like...
Ok guys here's where I'm at now!!
Bin driving the truck around some, Blew a
spark plug out!! Then while replacing the rest
one stripped off. So another project!!
Also got the 4 wheel drive to work but the lever keeps
slipping forward. And haven't got to the leaking
transfer case yet. Well ill...
HI Guys,
just double checking some info to make sure its correct!
My transfer case tag says 208 c 1 so making sure its an 27 spline input which
would bolt up to an th350 or a 700 r4 tranny? thanks
HI Guys,
just double checking some info to make sure its correct!
My transfer case tag says 208 c 1 so making sure its an 27 spline input which
would bolt up to an th350 or a 700 r4 tranny? thanks
Hi Guys, Ended up testing a few circuits and found no
power in any way at the B1 and the C16 circuits going into the ecm
so I ran a hot wire with an inline fuse to both and it fired right up.
Now I'm gonna see y it won't go into 4x4
Thanks for everything
Hey guys probably a stupid question!
But looking at the diagram above for the
ecm circuits which way should I be holding
The plug in my hand to cordinate with the diagram?
If I'm holding the plug and have the clip of the
plug on the left side and the #1 at the bottom then the left side
of the...