84_c10_GMC's latest activity
-
84_c10_GMC replied to the thread What have you done to your square lately??.Got the driveshaft in, shift linkage on, engine oil changed, oil pump primed, and dropped battery in. Tried to use the key to bump the... -
84_c10_GMC reacted to Cipriano's post in the thread What have you done to your square lately?? with
Like.
Got my new speakers in the dash and also polished the haze out of the bezels. I bought new 168 bulbs but the yellow plastic thingie was... -
84_c10_GMC reacted to Terlingueno's post in the thread What have you done to your square lately?? with Like.
I received a Summit Racing gift card awhile back and needed to spend it on something for the Suburban. My current fuel pressure...
-
84_c10_GMC reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
Got everything mounted up and wired today just got to figure out what to do with the grille I'd have to chop up the stock one pretty...
-
84_c10_GMC reacted to Terlingueno's post in the thread What have you done to your square lately?? with Like.
Installed a pair of .074 X .052 metering rods in place of a pair of .073 X .052's into the Eddy 1405 because I think I need just a teeny...
-
84_c10_GMC reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Tried the C3500 intermediate shaft. I used a 88-2002. Got it in a salvage yard 25 bucks. Had to do just a little grinding on the stub...
-
84_c10_GMC reacted to WFarm's post in the thread What have you done to your square lately?? with Like.
When I pulled the distributor to remove the intake manifold I found a wiring mess at the distributor. I posted earlier about the one...
-
84_c10_GMC reacted to gilby959798's post in the thread What have you done to your square lately?? with Like.
I didn't do anything to mine, I'm a few hundred miles away from it but I spotted this at the Sam's club
-
Have you figured out the problem as of yet? If no, what troubleshooting and/or fixes have you tried? How many miles on the...
-
Are you sure it is the 3/4 shift bouncing or is it the TCC hunting? Could be an issue with the TCC lockup solenoid? Does the issue go...
-
Find out quick, or you will need another transmission rebuild.You can check your flyid,if it's OK. You need get a transmission pressure...
-
84_c10_GMC reacted to HUFFINCOSMOLINE's post in the thread What have you done to your square lately?? with Like.
-
84_c10_GMC replied to the thread What have you done to your square lately??.Ah in the transmission pan. I bought the derale pan and it had a spot on the side for it. Right below where the transmission lockup plug is.
-
84_c10_GMC reacted to Camar068's post in the thread What have you done to your square lately?? with Like.
where did you put the sender for the gauge? In line, trans port? sorry for confusion.
-
84_c10_GMC replied to the thread What have you done to your square lately??.Test fitting the ash tray gauge holder
-
