84_c10_GMC's latest activity
-
84_c10_GMC replied to the thread What have you done to your square lately??.Buddy made me a gauge holder to test fit for the ash tray. Gonna end up putting the transmission gauge there instead of removing the clock. -
-
84_c10_GMC replied to the thread What have you done to your square lately??.Sorry Tying what in?
-
84_c10_GMC reacted to Sgt Gus's post in the thread What have you done to your square lately?? with
Like.
With all the ash tray ideas I thought you might like my daughter's. -
This is a fraudulent site even though it has an https:// in its address. It cost me $15 to find out and had to cancel my VISA card today...
-
84_c10_GMC reacted to 73 cheySuper's post in the thread What have you done to your square lately?? with Like.
Installed these window rubbers. I remember finding them at a swap 10 years back, finally got to it. They had a couple issues.....1 clip...
-
84_c10_GMC replied to the thread What have you done to your square lately??.I got my auto meter tach in today. Thought I’d ordered a 3” but it’s actually 2 5/8” which is perfect for mounting on the column and not...
-
84_c10_GMC reacted to PrairieDrifter's post in the thread Tightening down front yoke nut stops NP205 from turning with Like.
Sounds like maybe a bearing issue. Thrust washer maybe. Check out GebBuilt on YouTube, he goes through one by the book. He also became...
-
84_c10_GMC replied to the thread CCV Delete on L5P Duramax – Worth It or Not?.I’m not deleting it on mine but I’m doing the vse reroute. That is suppose to put the oil back into the valve cover better than the oem...
-
84_c10_GMC reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Got the motor and transmission in. Cleaned up the core support. Drilled the spot welds out on the brake booster/steering column mount...
-
84_c10_GMC replied to the thread Missing piece?.Thanks just ordered the entire kit. Probably could use new spring anyway!
-
https://www.ebay.com/itm/224924024371?_skw=th350+linkage+bushing&itmmeta=01KVNJCP73YZ32HFAJJZEMHHF7&hash=item345e843e33:g:Z7MAAOSw4VViTYu...
-
84_c10_GMC replied to the thread Missing piece?.That’s what I was thinking…… have to dig around inside the truck and see if I can get lucky and find it….
-
Iirc, there should be a half moon like bushing inside the cup.
-
Seems like I’m missing a piece that keeps the spring from pushing thru and. Maintains tension on the linkage. Anyone know what it is...
-
-
When I did something similiar. I mounted my new pump by the tank. Took the fuel pump pushrod out of the engine, and used my existing...
