-
-
Camar068 replied to the thread Made a new tool.lol I don't mind removing the bed, gives me time to look at other stuff while I'm there. -
Camar068 replied to the thread 1984 350 Starter Upgrade to new style Part number request.that link goes to Toro.com Did you mean DBElectrical? If so, I can vouch for the LS starters quality and being a lot cheaper...
-
Camar068 replied to the thread 4l80e shifting issues.I've got a 4l60e that I've been expecting to go (no issues as bad as yours). Anyway, I read up on Lubgard and reviews. I felt they...
-
Got the plates for tow alignment from TMR. They had them on sale, and I had a 30.00 credit... so I got them for 33.00 shipped. Used them...
-
Camar068 reacted to 84_c10_GMC's post in the thread What have you done to your square lately?? with
Like.
Ah in the transmission pan. I bought the derale pan and it had a spot on the side for it. Right below where the transmission lockup plug is. -
So i was up late trying to get a secondary pwm map worked out for the supercharger but as it turns out the holley can only do 1 PWM per...
-
Camar068 replied to the thread What have you done to your square lately??.where did you put the sender for the gauge? In line, trans port? sorry for confusion.
-
Camar068 replied to the thread What have you done to your square lately??.@84_c10_GMC how/where are you tying in?
-
Camar068 replied to the thread What have you done to your square lately??.original or after market?
-
Camar068 reacted to 86k20-ds's post in the thread What have you done to your square lately?? with Like.
I stuck on a bow tie to my grille, and put a patriotic plate on the front bumper. Also replaced the coolant overflow reservoir and...
-
Camar068 replied to the thread Unusual way to bleed brakes. Just might help someone..I did this while after cracking the bleeder open for gravity bleed, tapping with an rubber mallet. You could see the air bubbles come...
-
Camar068 reacted to dans78c10's post in the thread Wire for oil sending unit/gauge cannot be found...help! with Like.
You guys are awsome! I am working in the shop today, and will be hooking these wires to the sending units. This checks one more thing...
-
Camar068 reacted to Ajax19's post in the thread What have you done to your square lately?? with Like.
I have plans to add a fuse/relay box for all my other lights so I'll add that in then
-
Camar068 replied to the thread What have you done to your square lately??.yes it is. The lights will draw power directly from the battery and not the trucks harness. You current power to your lights would...
-
Camar068 replied to the thread What have you done to your square lately??.good time to put the relay harness on your headlights as well.
-
-
Loading…
-
Loading…
