-
-
BI had to replace my u joints in my rear driveshaft (82 k10). Didn’t think about it but I forget which end goes to the transmission and...
-
Bben82k10 replied to the thread My dash lights and gauges don’t work..I’m going to save my Pennie’s and get a Dakota digital and hope for the best..
-
Bben82k10 reacted to jeff bowen's post in the thread My dash lights and gauges don’t work. with
Like.
Same here buddy - I have an 84k5 and my lights quit working after I tried LED's also worked great for a week and then bam - but my... -
BCarpet and speakers in the corner! Black aluminum trim.
-
BPerfect space for a sound system I reckon. But of sound deadening on the back panel really stiffens it up too.
-
BI just had KilMat+Noico foam back when I had a bench seat. I just set stuff on top of the rear cross sill, never had a tray or anything...
-
BThat space is where your sub-woofer goes. One 12" duo voice coil speaker. Air space is correct. Pulled it out to swap the speaker...
-
BThe previous owner of my rig cut 2 big holes in the back of the cab for some sort of vents that constantly leaked. I had to to do some...
-
BLandscape fabric and fiberglass resin to “harden” the original cardboardesque black thing. If I can then glass in a good behind the...
-
BI did the lmc carpet cause I did not have any better thoughts. Interested in replies. Eric
-
BWhat are you guys doing for your wall behind the seat? I’m not sure if I want to do carpet but I don’t want to leave it bare either...
-
Bben82k10 reacted to SquareRoot's post in the thread Forever Sharp steering wheel installed. Beautiful with Like.
Finally got fed up with the sticky OEM wheel. After much research I found what I was looking for. A half wrap from Forever Sharp. I love...
-
BI ordered samples of both. In my lay opinion, the only difference in the essex and the normal was the lines-per-inch of the fibers...
-
-
Loading…
-
Loading…
