Ryanbrown36
Latest activity Postings About
-
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help. -
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Okay going to re do it now, I just removed the fuel pump before I did the valves and a small circular plastic piece that looked to be...
-
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Okay, will go over it again tonight. And just for learning purposes if the pushrod wasn’t spinning that would mean the lifter is collapsed?
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.I rotated about 30 degrees at a time tightening each rocker until resistance and continued until they all had no play and then did 3/4...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.I was adjusting by tightening until there was a a bit of drag when spinning the pushrod and then 3/4 of a turn in after that, if I...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.I bought an additive for the lifter noise with a detergent and also did about 400ml of atf, so basically a quart or trans oil. But no...
-
I have have a similar problem with a SB400. No lifter noise at all, unless I run the engine at 3000 RPM+ for an extended period of time...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Yes I may try some different oil. no worries at all, the more opinions and ideas the better lol
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.I would like to hope so lol, thanks for the help. Appreciate that, ya not many around me but see the odd one out and about
-
Ok. I feel you can reasonably eliminate that then. Much more knowledgeable folks here then I for suggestions. Good luck getting to the...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.I tried adjusting it while running but made the noise the entire time, I just hear it from that rocker but I can’t be sure it’s that, I...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.It sounds to me like #7 and I’m pretty confident it’s coming from there after hearing it run with it off but will check the little...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Yes really hoping that doesn’t happen, it’s hydraulic but have been using Lucas conventional 10w30
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Okay, I didn’t build the motor myself so not too knowledgeable about valve train stuff so that makes sense, will do some more research...
-
Ryanbrown36 replied to the thread Sbc 350 lifter tick help.Yes they all rotate
-
-
Loading…
-
Loading…
