motionz
Reaction score
10

Latest activity Postings About

    • motionz
      The piece who was sucked out of the carburetor base gasket is the first major fault I’ve found! Yesterday, I cleaned the carburetor...
      • IMG_9792.jpeg
      • IMG_9791.jpeg
      • IMG_9790.jpeg
    • motionz
      strange i get the message when i checked out that a "new European packaging law is active (PPWR)" ? Maybe it has changed in the...
    • motionz
      Yes, finally a major find that is most likely the cause! Although I still find the irregular spark plug spark suspicious. But first...
      • IMG_9773.jpeg
      • IMG_9785.jpeg
      • IMG_9774.jpeg
    • motionz
      By now, everything from the battery to the ignition has been measured and/or replaced: - +12V cable from starter motor to fuse box -...
      • IMG_9772 (1).jpeg
      • IMG_9768.jpeg
      • IMG_9767.jpeg
      • IMG_9770.jpeg
    • motionz
      Excuse me but the 400rpm is on LPG en gasoline, sparkplugs are new and can't see already the state of them. In this test test phase I...
    • motionz
      I have checked the transmission modulator also with brake cleaner, no problems. The vacuum advance I have allready checked with a...
    • motionz
      I have since connected a timing light next to the vacuum gauge so that I can check these parameters with every change. Spraying brake...
    • motionz
      First of all, I pinched off the following vacuum hoses: - brake booster - EFE and PCV - all hoses from the Evap Canister; there is...
      • IMG_9733.jpeg
    • motionz
      Have done a vacuum measurement on PCV port value = steady 16inHg at high rpm, see picture. Engine runs very poorly and make sucking...
      • IMG_9729.jpeg
    • motionz
      Ah great, thanks for the overview! In the meantime, I have tested and fixed a number of electrical issues, such as: - Replaced the...
    • motionz
      Oke I wil get one! Where can I connect the vacuummeter and what is the correct value?. @bruce I will definitely check the carburetor...
      • IMG_4678.jpeg
    • motionz
      I have measured the spark plug wire resistance and was in between 3000-8500 (longest) Ohm. Unfortunately, I don't have a meter to...
    • motionz
      Hello Lars yes thx for the tip ! the battery is a healthy Optima Red Top from 2 years old. Charging circuit worked like it should be...
    • motionz
      Hello, I have a problem/challenge with my 1978 Big10 350ci V8. A few months ago, the engine suddenly started running very poorly during...
      • IMG_9060.jpeg
      • IMG_9115.jpeg
      • IMG_9114.jpeg
      • IMG_9105.jpeg
      • IMG_9113.jpeg
  • Loading…
  • Loading…

Latest posts

Forum statistics

Threads
48,962
Posts
1,081,974
Members
43,873
Latest member
CubsFan79
Top