-
-
mjck5 replied to the thread torque lock up.that's what's confusing me, if i unhook term D the only ground i should have is the fourth gear switch so it should be grounding when it... -
mjck5 replied to the thread torque lock up.it is a 2 wire solenoid and a 1 wire 4th gear switch, right now i have it wired like the attached diagram of what's inside tranny and it...
-
Make your life easy I did not read your post it was too long for me. You do not need an ecm to control any 700r4. You do for a 4l60e...
-
hey everyone, more tcc lock up questions i have been trying to get my tcc lock up working as it should, i have a 86 k5, i replaced the...
-
-
I doubt you have an ecm, at most you have an esc that is most likely not hooked up.
-
You are probably right. To the best of my knowledge only California emissions squarebodys had an ecm in 86.
-
mjck5 replied to the thread torque converter lock up.hey everyone, more tcc lock up questions i have been trying to get my tcc lock up working as it should, i have a 86 k5, i replaced the...
-
-
hey all, i am planning on putting a corvette servo in my 86 k5 and was wanting some opinions on if also upgrading to the superior super...
-
Flex plate bolts 65 torque converter 35 both with thread locker.
-
hey everyone, i had to replace my flex plate in my k5 with a 400sb and a 700r4 tranny, i cant find any reliable torque specs anywhere...
-
mjck5 replied to the thread torque converter lock up.thanks everyone for all the responses, pretty sure my tcc is hooked up correctly i think i just need to get a tach so i can see it...
-
Hey all, i have a 86k5, originally had a 305 but i swapped it out for a 400sb years ago, when i did that i got rid of all the emissions...
-
-
Loading…
-
Loading…
