Ontheboulder
Latest activity Postings About
-
-
Ontheboulder replied to the thread What have you done to your square lately??.Getting ready to install a new stereo since the cheapo died. Any ideas on where to mount an Amp in the cab? No room under the dash... -
Ontheboulder replied to the thread What have you done to your square lately??.finally got a chance to swap the castor shims from front to back to try to get rid of the darting left to right eliminated. seems to...
-
I highly recommend NOT lowering the tcase. Lowering the tcase crossmember tilts the engine/trans/tcase since it doesn’t change the...
-
Ontheboulder replied to the thread track bar for 1987 V2500.Exactly! Get the steering right then tackle any other issue. I can do a drop of the transfer case to improve the angle
-
I get what you’re saying BUT your choice to use shims or not or which direction needs to be focused on caster first since steering is...
-
Ontheboulder replied to the thread track bar for 1987 V2500.not sure what the previous owner had done , I may and most likely re- installed them wrong but who knows!! will find out soon
-
Case in point... well, two cases actually. Both of these trucks are lifted (4" and 6") and have the fat side of the shims toward the...
-
Ontheboulder replied to the thread track bar for 1987 V2500.yup but by looking at it the pinion angle is not bad with them in or out, gonna put them back to the rear to see how it goes, don't look...
-
They are only in backwards if someone was trying to help caster. If they were trying to help pinion angle, they were installed properly.
-
Ontheboulder replied to the thread track bar for 1987 V2500.took it to the shop castor is negative 4.3 degrees should be in the positive range of 7-8 degrees. the castor shims are in backward if...
-
“Diving” implies suspension movement, not steering. Maybe give a clearer explanation of what it’s doing and when. I agree with bucket...
-
In general a panhard bar is a bad idea with leaf springs. People think they keep the frame and axle from moving side to side when in...
-
Ontheboulder replied to the thread Castor shims.just an update on the castor issue. took to Les schwab for alignment check. definitely need some castor work. the shims are on the wrong...
-
The top ball joint should be farther toward the rear to give positive Caster!!!!!!! That is the top of the spindle should be leaning...
-
Yeah, OP also has a thread asking about a track bar to help with steering wander. In that thread too, it was mentioned that it could be...
-
-
Loading…
-
Loading…
