Trucksareforwork
Latest activity Postings About
-
-
Trucksareforwork reacted to Turbo4whl's post in the thread electric choke/ operating in reverse at start up with
Like.
The choke light works backwards from what some other systems work. Turn the ignition on, power is fed to the oil pressure switch. The... -
It's great that this thread is still going. Your suggestion is exactly what I decided to do. I did check the return line and all seems...
-
Trucksareforwork replied to the thread Rochester Q-Jet running rich.I must be in the minority here. I wouldn’t chase this “problem.” You may have the choke adjusted a little too tight so that it runs a...
-
Trucksareforwork replied to the thread fast idle/curb idle on Rochester 2GV.great. be sure your vacuum advance is disconnected when you are setting timing. (not to be condescending...happens all the time).
-
Trucksareforwork replied to the thread fast idle/curb idle on Rochester 2GV.Finding the sweet spot to me would be to check and set timing, then set your hot idle and adjust idle mixture (and reset idle to your...
-
Trucksareforwork replied to the thread fast idle/curb idle on Rochester 2GV.I don’t know your setup. For instance, in the mid 80s, A stock automatic c10 V8 would idle somewhere around 550-600 rpm in drive. You...
-
Trucksareforwork replied to the thread fast idle/curb idle on Rochester 2GV.Is it possible that your choke is working fine but you have a hefty vacuum leak? Like are all vacuum ports plugged? That’s one thing...
-
Trucksareforwork replied to the thread Chevy 14 bolt - gov bomb locker???.Yeah I see it. The OPs just looks less built up. I see the cone shaped difference now.
-
Trucksareforwork replied to the thread Chevy 14 bolt - gov bomb locker???.1981 g80 gov loc 14 b ff dually. I serviced the diff last summer and this is what it looked like. Only pics I have. Look similar to op.
-
-
Trucksareforwork reacted to Matt69olds's post in the thread 84 OEM Cruise Control Module/LS Swap with Like.
Cruise control is a completely separate harness on these trucks. The cruise module gets its speed signal from the VSS on the bs l of the...
-
Trucksareforwork replied to the thread Restoring A/C.Getting A/c to run is a rewarding project. You have a lot of stuff missing. The vacuum lines to the vacuum canister on your passenger...
-
Trucksareforwork replied to the thread Dana 60 axle play.Got it done with a new 9/16-18 nylock nut. I also replaced front and back shocks with some kyb monomax shocks. I think the shocks were...
-
@Trucksareforwork you killed the pinch bolt on the pitman arm? If so, grab a grade 8 bolt and lock nut from a hardware store and...
-
Trucksareforwork replied to the thread Dana 60 axle play.Yeah. I think I’m lucky. I sheared the threads off the nut. Bolt looks good. I just ran a thread chaser over it. And yes, I’m sure I...
-
Trucksareforwork replied to the thread Dana 60 axle play.Had on my front end checklist to “torque pitman arm.” Torque setting from the interwebs? 180 ftlbs. Sheared off my nut threads...
-
-
Loading…
-
Loading…
