Jawzjeep
Latest activity Postings About
-
-
Jawzjeep replied to the thread New Square Jimmy owner, starts with the floors.Sounds like lots of fun. My K5 was similar and that the floor was so rusted out the seats were falling in and it had no rockers. Lots of... -
-
Jawzjeep reacted to TCulpepper's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with
Like.
I didn't drive the truck much, and now that I think about it, I may have only been making sharper right hand turns on the route I took... -
Jawzjeep replied to the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns.My 78 k5 did the same thing. Eventually the case will slip as long as it's not in loc, its a 203 thing. Best conversion kit is one that...
-
Jawzjeep reacted to Smtty58's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with Like.
What shape are the axle joints in? Rusted, seized joints will cause this also.
-
New here, we have a 73 k10 and a 78 c30. Will be looking for answers and asking questions along the way as we work through something’s...
-
Welcome! Answers come at a price, we’ll need pics of said trucks at some point. :Big Laugh:
-
Jawzjeep reacted to H2OnSnow's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with Like.
And know that even with the t-case in the normal position and not Loc, you can still get some lopey, hoppy feel if you do a full lock...
-
Jawzjeep reacted to Goldie Driver's post in the thread All time 4x4 / NP203 Truck Questions, hard to make tight turns with Like.
My 1st instinct would be to see if it is in Loc as that will cause it to fight on turns. Both ways, however, not just right. Just get...
-
Don't think you have had a "proper" alignment if the tire is wearing. 2 different ways to cure this problem, 1 is to install a shim...
-
Jawzjeep reacted to Mr Clean's post in the thread What have you done to your square lately?? with Like.
Got the driverside firewall almost done. A little more grinding and welding a few pin holes, the finish line is in site.
-
Jawzjeep replied to the thread What have you done to your square lately??.Got my new manifolds in, welded my exhaust back in and installed my transfer case with a newly swapped 32 spline input. This 700 to 400...
-
Jawzjeep replied to the thread Hello everyone, I'm Walter; I'm new here..Congrats that's a clean Suburban
-
Jawzjeep reacted to WFarm's post in the thread What have you done to your square lately?? with Like.
When I pulled the distributor to remove the intake manifold I found a wiring mess at the distributor. I posted earlier about the one...
-
Jawzjeep replied to the thread Vacuum issues.On my 91 that splitter you're talking about has a line to cruise control, to the round ball you're talking about, a white hard plastic...
-
-
-
Loading…
-
Loading…
