1low4x4's latest activity
-
Are those the umbrella style seals that are in there? I think they will ride and still shed oil from the valve stems. But again, I'm not... -
1low4x4 replied to the thread Finally got a running 65 C10.Here’s a question. I was noticing that the valve stem guide Seals are being held up in many instances by the inner spring. Will these...
-
-
1low4x4 replied to the thread Finally got a running 65 C10.I’m going to wait to drop the engine in until I can buy a new distributor. This one has seen better days. Cap coil and rotor too. Work...
-
-
-
1low4x4 replied to the thread Finally got a running 65 C10.I ended up using an old spark plug wire as suggested earlier. Got it close to the top, stuck the plug wire in as far as it would go, and...
-
With the piston down, I had a buddy hold the valve up with the handle end of a screwdriver through the intake port while I compressed...
-
1low4x4 replied to the thread Finally got a running 65 C10.Got the springs in, rockers on and adjusted, clutch on, transmission set. Intake manifold on, need to slap the motor mount brackets on...
-
Looks good to me. You have the bearing part facing the clutch.
-
1low4x4 replied to the thread Finally got a running 65 C10.Is this the correct placement for the throwout bearing? I guess that’s what that’s called.
-
-
1low4x4 replied to the thread Finally got a running 65 C10.So I’m having trouble compressing my springs enough to get the little retainers in. I guess I should have done this before I put the...
-
-
-
1low4x4 replied to the thread Finally got a running 65 C10.Installed “The file is too large to be uploaded” I am so sick of having to crop my photos for this site
-
1low4x4 replied to the thread Finally got a running 65 C10.Now that I look at the 54 piece picture I posted it says it has a 7/16 tap but I swear none of them came close to fitting. But that kit...
-
1low4x4 replied to the thread Finally got a running 65 C10.This crank has 7/16-20 thnreads I just checked and ran a tap through it to clean it out with some WD40 so now I just ghave to find a...
-
1low4x4 replied to the thread Finally got a running 65 C10.Got the freeze plug installed. Stopped at horrible freight and bought a $40 pulley remover/installer. It doesn’t work on my crank...
-
