1low4x4's latest activity
-
@Frankenchevy has a 327 with a freeze plug in that hole. -
I bought that dampener remover/installer kit. I am shocked there isn't something in there that would work on the crank of your engine...
-
1low4x4 replied to the thread Finally got a running 65 C10.It had a rubber expansion plug in it that was leaking profusely
-
1low4x4 replied to the thread Finally got a running 65 C10.Wasn’t on the engine. I was able to find the part number that supposedly fits, 555-024
-
1low4x4 replied to the thread Finally got a running 65 C10.Trans The two light colored spaces where my fingers are pointing is where the needle bearings sit on the female section of the other...
-
-
1low4x4 replied to the thread Finally got a running 65 C10.Figured out the trans needle bearings, and got it all back together. I hope it works right. My freeze plug for that hole in the back...
-
-
1low4x4 replied to the thread Skool me on timing w/o timing tab.my fears/concerns exactly. The springs that came with the cam, I’ll have to look at the box. A new hei distributor I need to order
-
1low4x4 replied to the thread Skool me on timing w/o timing tab.Yes, the 283 out of the 65. The engine is still out of the truck
-
This is for the 283 you’ve been working on correct?
-
Many companies sell these. Look "small block chevy timing tab" Find originals too: CLICK HERE
-
You would definitely need to mark 0, and then some way of measuring the degrees, mark 10BTDC at the very least, but you really need the...
-
Just use a piece of stiff wire and bolt it to the water pump or wherever convenient to make a pointer, then find TDC using a piston stop...
-
Disclaimer: It's been a decade since I timed an engine. I remember how to unplug (and plug the line) the vacuum advance for initial...
-
1low4x4 replied to the thread Finally got a running 65 C10.Not yet. Waiting on the rebuild kit
-
1low4x4 replied to the thread Finally got a running 65 C10.Got the seals in, stopped and bought a valve spring compression tool (I think I’ll take it back and make one out of an old wrench) and...
