G
gmbellew
Latest activity Postings About
-
-
Ggmbellew replied to the thread AC Compressor Constantly Running.the low pressure switch serves that function. it is on the drier.
-
Ggmbellew replied to the thread AC Compressor Constantly Running.low pressure switch only. if it is really hot and humid, I dont know that it will cycle...
-
Ggmbellew replied to the thread 700R4 Gear “Hunting”.I edited my post. The wire I am thinking of is actually on the gage/idle fuse. It might be purple down by tthe transmission, running on...
-
Ggmbellew replied to the thread 700R4 Gear “Hunting”.There is a TCC wire that is also on the gage/idle fuse. Runs along the driver side of the trans. I had a rub through that blew the fuse...
-
Ggmbellew replied to the thread Air Conditioning Advice Needed.Sounds like maybe the compressor is locked up and when the clutch engages it bogs down the engine?
-
Ggmbellew replied to the thread Sanden AC compressor for Suburban with front and rear air.Dryer and orifice tube for sure. The compressor I linked above works with stock hoses. Condenser is your call, really. Make sure the fan...
-
Ggmbellew replied to the thread Sanden AC compressor for Suburban with front and rear air.this is what I am running in my dual air 1990. with a good fitting shroud, good clutch fan and a small pusher I run with AC on attached...
-
Ggmbellew replied to the thread Temperature hunting at stop lights.Does the shroud sit up nice and tight to the radiator? The shroud needs to be up against the radiator for the fan to pull the air...
-
Ggmbellew replied to the thread Help finding the DRAC 1990 V1500 Suburban.Is that a 1990 cluster? Never had my 1990 cluster fully out, so not sure what the backside looks like. My DRAC I have had out and it...
-
Ggmbellew replied to the thread Help finding the DRAC 1990 V1500 Suburban.DRAC is under the dash below the radio. If you remove the crossover duct it will be visible. It sets on the backside of the metal dash...
-
Ggmbellew replied to the thread timing issue.timing is set to 0 with the bypass unplugged. Do not plug in the bypass with the motor running. If it was running fine before, I’d...
-
Ggmbellew replied to the thread 1987 V10 305 TBI - Good until it just falls on its face..I’d look very closely at the plug wires, distributor cap, and rotor. Could be stray voltage if the ICM is ok. Wires with cracked...
-
GI found a connector i missed on the driver's side firewall with a tan wire and a gray wire. It took me a while to find the other end...
-
Ggmbellew replied to the thread 700R4 Gear “Hunting”.solenoid is accessible with a pan drop. but if it doesn't hunt in D, it probably isnt the TCC lockup unless yours has been modified to...
-
Ggmbellew replied to the thread 1987 GMC V1500 TBI crank but no start.If you get the fuel pump sorted, you might verify timing is right with rotor pointing at no 1 TDC and the wire firing order.
-
-
Loading…
-
Loading…
