Matt69olds
Latest activity Postings About
-
-
Matt69olds replied to the thread What are these wires?.The plug (cruise control lever) in the first picture plugs into the second socket (cruise control harness) in the second picture... -
Matt69olds replied to the thread Remove O2Sensor.You need some serious heat. Got a torch?
-
Matt69olds replied to the thread 700R4 TCC Lockup Issues.I used a 4th gear pressure switch and a time delay relay. Power to the solenoid and relay coil come from the normally open brake switch...
-
Matt69olds replied to the thread Aftermarket A/C?.Either roll the windows down, fix the factory A/C (assuming it’s do equipped) or do it right and install aftermarket A/C. Why would...
-
Matt69olds replied to the thread Questions on carb upgrade.https://classicoldsmobile.com/forums/parts-sale-11/new-box-edelbrock-1904-795-cfm-quadrajet-186491/ The ONLY edelbrock carb I’d...
-
Matt69olds replied to the thread Heavy miss / stumble at 1500+ RPM..Does it have HEI? If so, temporarily disconnect the vacuum advance. If it improves or is solved, carefully inspect the tiny wires for...
-
Matt69olds replied to the thread Needs MORE POWER!!! (Tim Taylor Style!!!).Beat me to it!!! Nitrous is by far the best bang for the buck.
-
Matt69olds replied to the thread Help needed.The second set of contacts is either for the cruise control, or as others mentioned the lockup torque converter.
-
Matt69olds replied to the thread TH400 leak around speedo drive.That’s an easy fix. You need the O ring that goes around the speedo housing, and the small seal that goes inside the housing that seals...
-
Matt69olds replied to the thread Questions on carb upgrade.You can’t get more reliable than a properly rebuilt Q-Jet. And unless your willing to spend some time tuning, i seriously doubt you...
-
Matt69olds replied to the thread Knocking/ticking noise after oil pan gasket.Remove the oil filter, cut it open. Use tin snips, don’t use a hacksaw. Once the filter is cut apart, remove the filter media. Spread...
-
Matt69olds replied to the thread bulkhead fitting sludge.It’s some kind of sealer the factory used to keep water out of the connector. It’s definitely some gooey stuff.
-
Matt69olds replied to the thread Quadrajet Secondary issue?.Start by a detailed and careful inspection of the fuel system. Check the lines, especially the rubber hoses at the tank. Any cracks or...
-
Matt69olds replied to the thread TH400 Slipping When Warm - Chunks in Oil Pan.Hopefully you have read Nicks th400 thread. Throw away the spring, replace the broken plastic piston with the older aluminum. Be sure...
-
Matt69olds replied to the thread Nylon cam gear years.I’m pretty sure all the classic GM engines are interference engines. I know for a fact the Pontiac and Oldsmobile engines will bend...
-
-
Loading…
-
Loading…
