Recent content by 1 bad corvette

  1. 1

    Inside door handle install. How do you get the retaining clip connected from the pull rod to the lock mech, ?

    Thanks for the reply, I am trying to get the metal clip that holds the rod to the lock mech that allows you to open the door from the inside. It is where the clip #27 attaches from the rod to the latch.
  2. 1

    Inside door handle install. How do you get the retaining clip connected from the pull rod to the lock mech, ?

    I am having problems trying to get the retaining clip on the rod that goes from the inside door handle to the lock mech. inside the door. Any ideas or help ? working on my 80 GMC short box 4x4. Thanks in advance.
  3. 1

    Removing power window regulators glass down

    I did he same swap on my 82 K5 Blazer. You can do it by taking the bolts loose that hold the motor, the window channel on the wind wing side and the other track by the door latch. It takes a bit of playing around but is def. doable. Swap out the electric motor and regulator for a manual...
  4. 1

    82 K10 Gauge Issues, Dual Tank Question

    I have a 82 Blazer that was converted from a diesel to a carbed 350 gas engine and the wiring was all screwed up. I ended up going to Autozone , spent about 50 bucks and bought some aftermarket gauges and mounted them under the dash. Now I know for sure what my oil, water and volts are. If you...
  5. 1

    Dual tank switch kills the engine

    Hello, I am having the same problem as a previous poster, my truck would die instantly when switching from the right tank, [ which worked great, ] to the left tank then it died like you cut the ignition off. After being mad for a while I got underneath the truck and jiggled the wire harness and...
See more

Latest posts

Forum statistics

Threads
42,180
Posts
910,798
Members
33,675
Latest member
johnalen76
Top