Search results

  1. W

    th400

    Thanks for the help, I am new to this, First time I have had one apart before. I will try to document it as best as I can. I thought the trans was making some noise under part throttle but I haven't found much wrong with it other than some small looking hot spots on the steels. The thrust...
  2. W

    th400

    I need some help with inspecting some parts from my TH400, what should I be looking for? The rear planetarys look like they got hot, Is this normal? Any tips?
  3. W

    I think my th400 is making a grinding sound

    I have the slip yoke conversion from Denny's drive shafts, It sounds like a bad bearing, Do torque converters make any strange sounds when going?
  4. W

    I think my th400 is making a grinding sound

    I am trying to narrow down this grinding sound my 1/2ton big bock truck is making. It is like a metal on metal sound, almost like brake pads that are worn out. It seems like it it is in the middle of the truck , that's why I am thinking the trans. Here is some back ground: The th400 was a...
  5. W

    Members with 454 th400 10 bolt short wheel base trucks.

    I have a short bed c10 and 496 with a th400 from a short bus, I had the same slip yoke made and drive shaft from denny's. Very nice part and good people. I don't remember the length but followed denny's instructions and it fit great.
  6. W

    adding itermittent

    I am working on a 1984 c10, I just replaced the wiper switch in the column and want to know if I can add intermittent wipers. Right now the wipers seem to run slow in both low and hi speed but they do change speed when switched, without the delay module installed. This is the way the...
  7. W

    key buzzer switch

    yes the little plastic thing with two copper tabs. While I am in the column fixing everything( high beam and turn signals were broken) I would like to replace it. I don't think they make them anymore.
  8. W

    key buzzer switch

    Where can I find a key buzzer switch for a 1984 tilt column? Mine broke into dust when I pulled it out.
  9. W

    need help 496 in c10 steering brackets

    I ended up getting a pump with reservoir from a 84 c20 , It fits a bit better but the return line is close to the frame. I think I can make it work Running brackets from Tuffstuff . I wish I could have found stock brackets, as the ones I have seem to stick out to far. I don't have any...
  10. W

    need help 496 in c10 steering brackets

    I am in need of some help, looking to see what others have done? I am have a 1984 c10 that I am putting a 496 bbc in it. Having problems finding power steering pump and brackets to clear the frame. Right now I have a long style water pump, 2 grove v belt pulley(on the crank) and the stock...
  11. W

    Trans Temp gauge, in factory bezel

    Years ago 1995ish B&M made a small gauge that I adapted to fit in lower left corner spot. It looked close to factory. It came with a sender that installed in the out line of the transmission. I was very pleased with it.
  12. W

    350 to tall deck 427 swap

    I am putting a tall deck in a 1984 swb , that I previously had in my 1992 chevy pick up. I plan on using the stock small block mounts. What manifold are you using? I have a dart single plane but I am debating using a rpm with spacers. I wish they would make a dual plane tall deck manifold...

Latest posts

Forum statistics

Threads
42,206
Posts
911,326
Members
33,703
Latest member
ChevyJGP
Top