Latest activity
-
That's always how it goes I was deep into my 388 when a brand new fully forged 489 short block popped up for less than I had in my build... -
Here's pics of a LWB square parts truck I have, the beds gone so I took pics for everyone. So If you look at these pics of a 16 gallon... -
This was the first thing I did when I got my truck. I'm assuming you undid the straps and left the L-brackets in place and that's why...
-
Pull the distributor cap. Rotate the motor by hand until the rotor just starts to move. Then rotate the engine in the opposite...
-
Misters don’t provide near as much cooling if it’s humid out. It’s the evaporation rate that make misters / swamp coolers effective...
-
Well… we redid the console today, dad had the flat pieces covered in carbon fiber vinyl but it just didn’t suit the car. We squirted...
-
WFO reacted to idahovette's post in the thread What have you done to your square lately?? with
Like.
I still have the 16.5 wheels and 8.50"mud grip" tires that came new on my 75 K20. They are mounted and still hold air and I run them... -
-
Got the driverside firewall almost done. A little more grinding and welding a few pin holes, the finish line is in site.
-
Got my new manifolds in, welded my exhaust back in and installed my transfer case with a newly swapped 32 spline input. This 700 to 400...
-
In my scenario above, no noise other than the miss. If it was an exhaust pushrod, the intake is still opening and able to fill the...
