Search results
-
W
87 ls swap a/c system wiring
Need some clarification on this myself....2000 lq4 with factory compressor going in a 79 k10 factory air truck.......what needs to be wired to the ECM? And to power the compressor its just the dark green wire to power side of compressor and the other pin to ground?.....I don't no if it matters...- wv79k10
- Post #9
- Forum: Tech Discussion
-
W
Ecm mounting solutions
Hey everyone I'm currently in the middle of a 6.0l swap in my 79 k10 the truck has factory AC so room under the dash is pretty tight. My stand alone harness was made to be mounted on the passing side of the truck inside the cab. With the ecm being so large the only solution I have came up with...- wv79k10
- Thread
- Replies: 5
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
LS Swap AC Location
What headers did you use? Sorry question is off topic- wv79k10
- Post #24
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
-
W
Lq4 swap question
I'm just starting a ls swap in my 79 picking up the motor Saturday. And I'm planning on keeping the th350 and 203 transfer case. So the dirty dingo mounts will be fine for that application and the AC will clear the cross member? The motor is a 6.0 out of a 2004 2500- wv79k10
- Post #34
- Forum: Engine Swaps (Gas) LS, Vortec, LT1 , etc.
