Search results

  1. chief_shotts

    What have you done to your square lately??

    Well I found that I was leaking coolant from the rear of the engine. I immediately assumed the worst and thought it was a blown head gasket or atleast seapage from the head gasket. I carefully examined the engine with a flashlight, clean paper towels, and a Little mirror. I was sure it was...
  2. chief_shotts

    Diagnosing mysterious sound from Tran/Tcase

    I solved my issue by ultimately adjusting the rear pinion angle up more. I shimmed it more than I thought was necessary based on the math a I did, but it worked so I'm not conplaining. I can now go very fast and it's a smooth ride.
  3. chief_shotts

    1991 Suburban 3/4 ton: TBI to Holley Sniper conversion - stupid, or worth it?

    Heres my two cents: When i bought the holley sniper Intended to use it with a built 383 stroker that i planned to put in my truck. But because i was impatient I immediately threw it on the old TBI 454 i had in my truck. I also swapped on a no name single plane intake manifold I had on the...
  4. chief_shotts

    Amazon special/ Led Headlights

    It's worth a try.
  5. chief_shotts

    Amazon special/ Led Headlights

    Funny I just saw somebody selling hella 5x7 housings local to me on Fb market place for a good deal. https://www.facebook.com/share/19tGnRKZCv/?mibextid=wwXIfr
  6. chief_shotts

    Amazon special/ Led Headlights

    If you have link to the specific bulb you used for instrument panel, I would be interested. I need to replace bulbs in the dash anyways.
  7. chief_shotts

    Amazon special/ Led Headlights

    I've heard good stuff about auxbeam. I was turned onto beamtech/techmax from another forum... so that's what I went with. It's hard to argue with bulbs that cost less and have better light output.
  8. chief_shotts

    Amazon special/ Led Headlights

    If your up to the task would you mind getting some photos of the beam pattern against a wall at 25 ft? Id be curious to see how the light pattern compares.
  9. chief_shotts

    Amazon special/ Led Headlights

    It would be interesting to see unfortunately I cant bring myself to purchase headlight at $200/piece.
  10. chief_shotts

    Nobody warned me about the MPGs on these square bodies!

    Check out what I said on post 59.
  11. chief_shotts

    Nobody warned me about the MPGs on these square bodies!

    The baffled tank is 100% the solution. When I installed my Holley sniper I plumbed my 87 baffled tank with new lines and installed an inline pump on the inside of the frame rail. I did all the work with supplies found in the sniper master kit... 5ish years later everything still works and I've...
  12. chief_shotts

    Nobody warned me about the MPGs on these square bodies!

    Was just about to say the same thing. And ya 100 dollars for a new gas tank is very reasonable deal.
  13. chief_shotts

    Amazon special/ Led Headlights

    Tested as follows. Kissed the wall with the front end and procededed to make a mark with tape slightly below the light hotspot. Backed up to 25-30 feet from the wall and aimed the lights at that mark. Here are three photos shot on iPhone 1billion ultra max pro. 1st is auto focused, 2nd low...
  14. chief_shotts

    Amazon special/ Led Headlights

    There has been a lot of previous discussion about headlights and led retrofitted headlight. Many claim that led bulbs cannot be used in reflector housing because of law and or because they do not have sufficient light cutoff and blind other drivers. Can't say for certain wether or not they are...
  15. chief_shotts

    4x6 H4 housings

    Thought it was too good to be true. Must be junk. Well since Amazon would probably take back used toilet paper.. I might aswell give these a shot. https://a.co/d/bjb7X9U
  16. chief_shotts

    Nobody warned me about the MPGs on these square bodies!

    For reference: 383 stroker. Crew cab. 35in tires. 4.10. Turbo400. Np 205. Holley sniper. 8-9 mpg. Sounds about right to me.. especially if you drive with conviction.
  17. chief_shotts

    Wiring A/C help

    I should mention the ac kick was worthless. The engine could not care less about the ac compressor. For reference the engine is a fresh 383 and the a/c system is all new.
  18. chief_shotts

    Wiring A/C help

    You can also just buy a pack of diodes and wire your own. Just look up fly back diode and watch a video to get the basic idea.
  19. chief_shotts

    Wiring A/C help

    First iteration I used a diode protected relay however that relay was located by the battery and the power wire fed clear across the engine bay to the ac compressor. Everything worked fine but I I realized with the diode relay so far from the ac compressor, When the ac compressor cycled on and...
  20. chief_shotts

    Wiring A/C help

    I added the relay bc I figured the og wiring didn't and a relay wouldn't hurt.
  21. chief_shotts

    Lifted truck driveshaft questions.

    i would and have done that for testing purposes because you can add and subtract washers easily but for final assembly use a chuck of steel.. i have a piece of square steel tubing used to drop my carrier.
  22. chief_shotts

    Lifted truck driveshaft questions.

    Your objective is to get all operating angles to cancel out or come close to doing so, and secondly try to keep operating angles to a minimum. When setting the pinion angle ignore the slip yoke joint and the driveline angles. Your goal with the pinion(driven member) angle is to match it to the...
  23. chief_shotts

    Lifted truck driveshaft questions.

    Hard to tell with pictures alone. I picked up a digital angle finder from Hoe depot for $30 +/- they had klein or milwaukee brand. Use that to measure engine/tran/tcase angle and rear pinion angle. The angles should match or the pinion angle should be a degree or two less. In my recent...
  24. chief_shotts

    Wiring A/C help

    Update for anyone this may help. Here is verified wiring diagram for the relay harness I put together to power my AC system. LPCO green wire triggers the first relay and sends power to a/c compressor. Second relay is a normally closed relay and when activated by the sniper (-) output at a given...
  25. chief_shotts

    Wiring A/C help

    terminas This relay I'm talking about has two 87 outputs. Bosch 0 332 019 155

Latest posts

Forum statistics

Threads
48,665
Posts
1,074,129
Members
43,333
Latest member
duncan_schawalder
Top