Search results

  1. Shoote

    Marine 502 into 1984 GMC 2500 454

    Exterior dimensions are the same. The cylinder bore size is different.
  2. Shoote

    BBC Clam Shells

    I swapped small block for big block on a 1985 2 wheel drive and a 1987 4 wheel drive. I used Energy Suspension in both clam shells and had only minor irritation when installing both engines. I don't believe it is the small block clam shells. Focus your attention on the other parts.
  3. Shoote

    Replaced ac evaporator now pressures are off

    Thank you for the responses. When I replaced the evaporator, I installed the orifice tube, so I know it is there and not damaged. I drove the truck and the air does blow kind of cold in 88-degree Florida weather, especially when it is not at idle. Is there anything else it could possibly be...
  4. Shoote

    Replaced ac evaporator now pressures are off

    Hi, I could use some help, it is getting hot in Florida. I replaced the ac evaporator on my 1987 V10. It has a Sandeson compressor. The system blew very cold but had a small leak at the connection by the orifice tube. I removed the 134a and thought I would replace the orifice tube while I...
  5. Shoote

    Anyone running this engine?

    I have a BP 454 in my V10. First engine used a quart of oil every 100 miles and had a lot of top end noise. BP paid a local shop for diagnostics three times with no definitive reason for the oil usage discovered. BP paid for the engine to be removed and sent back to them. Three months later...
  6. Shoote

    1987 Automatic transmission shift lever

    Thank you!
  7. Shoote

    1987 Automatic transmission shift lever

    Hi, Any advice is appreciated! I would like to replace the automatic shift lever on my 1987 V10. It works well, just has some rust on the chrome that will not come off. Is removal as simple as removing the pin at the base of the shift lever? Are replacements available or will I need to have...
  8. Shoote

    Engine/Trans help

    I have 1,000 miles on a BP motor. The mechanical fan has three inches of extension to get the blades inside the fan shroud. No issues so far with the water pump. BP does not make their own water pumps so I do not understand how the extension could cause an issue. I purchased Summitt brand...
  9. Shoote

    Torque specs, pitman arm, steering box to frame,

    Hi, Does anyone know the torque specs or where I can find them for a 1987 V10? I am not able to find the torque specs for: Steering box to frame. 70 ft pds?? Intermediate steering shaft bolt 35 ft pds?? Pitman arm pinch bolt 80 ft pds?? Pitman arm to drag link 35 ft pds?? I am going by...
  10. Shoote

    Engine/Trans help

    I have a 700 that I had the weak points corrected on behind a 502. I have run this set up since 2000. Pulled a 9000 pound Fountain, locally for years and have never had an issue. I have another stock 700 behind a Blueprint 454. Only 2000 miles so far, but no problems. I will use them to...
  11. Shoote

    Factory air cleaner/cold air setup?

    I had two of these fiberglass dual snorkels made. I painted each one to match the color of the truck I put them on. They have been on for 20 years and still work great.
  12. Shoote

    2001 2wd silerado frame 1976 cab and bed

    Thank you for the replies. I am on the fence with this project. Not sure if it is worth the effort.
  13. Shoote

    2001 2wd silerado frame 1976 cab and bed

    Hello, Has anyone put a 70's cab and bed on a 2001 frame? Both are 2wd. I did not see any threads when I did a search. Any input is greatly appreciated.
  14. Shoote

    Chassis brackets and rubber motor mounts.

    I have swapped a 305 for a 502 and a 350 for a 454. Used the small block mounts on both with no clearance issues. I agree with the trans mount may be the issue.
  15. Shoote

    1987 V10 with carb and dual tanks will not stay running

    the old switch was bad when I tested it. My mistake was installing the same switch that my 85 takes, thinking they are both carbs so the same switch should work. They dont.
  16. Shoote

    1987 V10 with carb and dual tanks will not stay running

    I agree, but I did not change the switch until about halfway through the process. It is out of the garage and running. First time in over a month. Thanks again to all who helped.
  17. Shoote

    1987 V10 with carb and dual tanks will not stay running

    I swapped out the switch about halfway through the the diagnostic process.
  18. Shoote

    1987 V10 with carb and dual tanks will not stay running

    I ordered the same switch I installed in my 85 GMC for the 87 Chevy. Both are running a carb so I thought it would work. You are right, it does not work. I just installed the switch for 87 to 91 and I have both fuel pumps running. I will take a test drive later and post a pic. Thanks to all...
  19. Shoote

    1987 V10 with carb and dual tanks will not stay running

    I did replace the tank selector switch. It said it was good for C K V and R trucks. I am guessing it is not because I took Ricko's advice and jumped the switch. When I did both fuel pumps worked. I have ordered another switch for 1987 to 1991 Chevy trucks. How can I make this switch work on a...
  20. Shoote

    1987 V10 with carb and dual tanks will not stay running

    About one year ago I replaced the solenoid valve because it was leaking fuel. I used the valve in the picture. Not sure if it is the old or new style.
  21. Shoote

    1987 V10 with carb and dual tanks will not stay running

    It does switch from tank to tank and it is a new switch, but I know that doesn't mean it's good. I will bypass and see what happens. Thank you.
  22. Shoote

    1987 V10 with carb and dual tanks will not stay running

    With the key on I have power to the tank selector switch through the tan/white wire. When I depress the switch to the left tank I get power to the tan wire. It does not stay hot, only when I depress the switch. When I let up on the switch the power stops. The gray wire for the passenger side...
  23. Shoote

    60 days in on my 90 day rebuild. Goin to try a motor upgrade next. Any advice on going from a 350 to a 454?

    It is an easy swap with the exception of a "few" pain points. Most have already been mentioned. I have done a 305 to 502 and a 350 to 454. The areas I had issues with are: Fan shroud Radiator must be bigger for 454 Radiator hoses Headers Ac system Motor mounts for big block TV cable bracket...
  24. Shoote

    1987 V10 with carb and dual tanks will not stay running

    Ignition on: Orange is hot Tan/white is hot Ignition off: Orange is hot Tan/white is not hot
  25. Shoote

    1987 V10 with carb and dual tanks will not stay running

    The last 1.5 years I could hear the fuel pump turn on as soon as I turned the key to start. I bought a Powe Probe so I have more information. Fuel relay on firewall Orange wire 12.5v Ground wire is good Tan/white wire 12.5 Green/white wire 12.4 Factory oil pressure switch wires 12.5 each...

Latest posts

Forum statistics

Threads
48,666
Posts
1,074,187
Members
43,340
Latest member
hauto85
Top