Search results
-
4150 2nd metering block missing holes
carb list 4777-2, block 11166. Missing holes on passenger side. (see attached photo) These passages link the high speed air bleed in main body to the main jet circuit in the block. Before I drill 0.025"... Should these holes be: 1. blocked both sides 2. clear on driver side only (as is...- Wes P
- Thread
- Replies: 6
- Forum: Carb Fuel Systems
-
Brake line repair
Hi all Having a bit of trouble with 3/16" front brake lines. Are the rings seen on the fittings normal or going to cause a leak? (photos below) Thanks! Wes- Wes P
- Thread
- Replies: 25
- Forum: Suspension, Steering & Brakes
-
Gear Vendors (Lessons Learned for driveshaft build)
Greetings! Some notes from my Gear Vendors experience: A Gear Vendors OD installation in a C20 (or, presumably, any regular cab, long bed, 2wd, automatic, unmodified suspension) does NOT shorten the drive shaft enough to allow conversion to a one-piece drive shaft. The GV kit comes with an...- Wes P
- Thread
- gear vendors over-drive overdrive
- Replies: 4
- Forum: Differential & Driveline
-
New, help please!
Greetings! Short story: I need the factory drive shaft angles and driveline angle (to verify the factory U-joint working angles) of a C20. If you have access to a C20, or the data, please help! Long story: I installed a GV overdrive behind a TH400 in an 85 C20. It was my intention to use a...- Wes P
- Thread
- Replies: 17
- Forum: Introduction
