Search results
-
B
New issue with my 83 k10
Thank you I'll give it a try. Also it still has a quadrajet so I'll see what that filter looks like if it has one Sent from my SM-G955U using Tapatalk- Brady01
- Post #4
- Forum: Engine & Performance
-
B
New issue with my 83 k10
So I've been fighting an issue with my truck for awhile now I can get it started by dumping gas down the carb then keep it running by dumping gas in the carb. After doing that a few times itll run on it's own for 10 minutes and die again. I replaced the fuel pump and cleaned the carb any ideas...- Brady01
- Thread
- Replies: 3
- Forum: Engine & Performance
-
B
83 k10 350 running bad or not at all
I'll be sure to check the mailbox, how much was it per reply then? Sent from my SM-G955U using Tapatalk- Brady01
- Post #4
- Forum: Engine & Performance
-
B
83 k10 350 running bad or not at all
Got it figured out. Coil took a shit Sent from my SM-G955U using Tapatalk- Brady01
- Post #2
- Forum: Engine & Performance
-
B
83 k10 350 running bad or not at all
Hi I was hoping someone might be able to help me on here. I was just driving my truck a few hours ago and I stopped for a minute in a parking lot to talk to my friend, and it started running like shit and the tach started bouncing around. I was able to keep it running for a bit then I was going...- Brady01
- Thread
- Replies: 5
- Forum: Engine & Performance
-
B
83 k10 turn signal issues
Thanks I'll try new flasher relays and let you know how they work out Sent from my SM-G955U using Tapatalk- Brady01
- Post #6
- Forum: Electrical & Audio
-
B
83 k10 turn signal issues
Hi I am running into an issue with my truck where the blinkers would occasionally come on solid but after turning them back off and on again they'd work and now they've quit working all together and now when I turn on my hazards they work but sometimes they come on solid. Any help is appreciated...- Brady01
- Thread
- Replies: 5
- Forum: Electrical & Audio
-
B
New Guy From Upper Michigan
Well 1 and 5 were crossed it runs good now but it still pops out the carburetor if you don't ease into it but so far everytime I've asked someone they pointed at the "quadrajunk" and told me to get a new carb and it should run perfect. Any recommendations on a carburetor? Sent from my SM-G955U...- Brady01
- Post #11
- Forum: Introduction
-
B
New Guy From Upper Michigan
Wisconsin? I bought the truck in park falls if your from around there Sent from my SM-G955U using Tapatalk- Brady01
- Post #9
- Forum: Introduction
-
B
New Guy From Upper Michigan
Thank you I'll give it a try and let you know how it goes Sent from my SM-G955U using Tapatalk- Brady01
- Post #8
- Forum: Introduction
-
B
New Guy From Upper Michigan
New guy from upper Michigan here I'm 19 and my names Brady. I recently purchased a 1983 chevy k10 Scottsdale and need some help. I drove the truck 2 hours home and had my dad check it out it ran good but definitely needed a tune up. So a few days went by and I put a new cap, rotor, plugs and...- Brady01
- Thread
- Replies: 14
- Forum: Introduction
