Search results

  1. Ryanbrown36

    Weird problem sbc spits and sputters till dies then start back up and its fine again

    I have a recently rebuilt sbc 350 wild a mild build, I daily drive it now that the project is done but recently about once a week I will be driving and after about 5 mins or less of driving it will spit and and sputter until it does, almost acts like the timing is insanely off but after I I come...
  2. Ryanbrown36

    Will a 8.5 Camaro 10 bolt axle fit in a 1981 squarebody?

    Might be a stupid question but I have no clue about rear ends. I have found a 1970 8.5” Camaro 10 bolt with 4.11 gears and was wondering if I can make it fit in my 1981 sierra. Thanks
  3. Ryanbrown36

    Cylinders washed need help

    I’ve recently completed my Sbc swap and just threw a new carb on it and it fired right up but was running a little rich, I went out yesterday to adjust the carb and I couldn’t get it to start after leaning it out (it was also very cold out) so played around with it and put it back to where it...
  4. Ryanbrown36

    Hydro boost brakes awful sound after finishing motor swap

    I have just completed a Oldsmobile diesel to sbc 355 swap and on my first start every sounded great but the first time I pushed my brakes in it make a grinding noise, and would go away when I let off, I’ve had the truck running about 10 times since then and would come on randomly at idle, now...
  5. Ryanbrown36

    Holley street warrior 600cfm for sbc 355?

    Any opinions on these Holley 0-80457s carbs I have a mild built sbc 355 with a Magnum cam Sealed power flat tops Polished crank Comp cams heavy duty roller rockers, lifters, valve springs ect Proformer RPM an intake, rebuilt 882 heads. It’s going to be my daily driver and looking for my best...
  6. Ryanbrown36

    Sbc 350 vacuum hose help

    Hey guys, just finishing my olds diesel to sbc 350 in my 1981 sierra and I noticed two vacuum lines that I’m not sure where they need to go. I’m assuming the small trans line goes to the manifold port on the back of the intake and thought these went to the carb but there’s two lines so not sure...
  7. Ryanbrown36

    transmission/oil cooler lines

    Hey guys, Im finishing up a Oldsmobile 5.7 diesel to Sbc swap and noticed my transmission cooler has 4 ports. I'm hoping to start it up this week in hopes of getting it on the road for a bit before winter and want to know what I should do with it. I'm not very knowledgeable about this stuff and...
  8. Ryanbrown36

    Olds 350 diesel to sbc swap

    Hi guys, I’m looking for some help on my olds 350 diesel to sbc swap, I have completed the swap and will be starting the truck up soon but have some questions about the tank situation. I have a dual tank setup and replaced the driver side tank with a new one to make sure there was no diesel left...

Latest posts

Forum statistics

Threads
45,557
Posts
986,191
Members
38,640
Latest member
clee
Top