Search results

  1. O

    Missing exhaust manifold bolt, whats size

    Missing a bolt, what size, hole was there for a reason at one time but I forget.
  2. O

    It could have been worse

    Driving home, no issues and suddenly fighting to keep her straight and outta the ditch. Seems the spline sheared at the hub, easiest way to repair ? replace spline, look for a used rear and do the whole lot, 90 v1500, 3.73 rear.
  3. O

    Need help with regards rear ac

    Decided to do my headliner, as the vehicle isn't my daily driver this was a long time project with a vacation in between. Well I went to put the rear panel in and I realized that something was missing. The hose with the clip about 4 inches down was attached to something and I have no idea, there...
  4. O

    Headliner what to do

    Well I removed the headliner as the sagging was finally getting to me. No issue getting in down, was thinking of options when I decided I would roughly clean the front one (suburban). Removed the old headliner and foam material, the outside towards the roof had some foam as well. Some bowing but...
  5. O

    What am I doing wrong

    Changing out the rotors, when I was at it, done seals bearings etc, used the old hubs not issues except when putting on the warn hub, the final snap ring won't seat.
  6. O

    Spider gear reinstall?

    Changed out leaking rear axle seal, so I done both sides and bearings. No issues with that, unfortunately during the process the two spider gears came out. And I am having a hell of time reinstalling them, what's the trick. Thanks
  7. O

    Cross pin bolt snapped

    Changing leaking rear axle seal, go to remove the cross pin and it's snapped, anyone any suggestion other than they kit skyway sells. Thanks in advance.
  8. O

    Adhesive on barn door rubber

    Got some replacement rubber from Jon Addington, (Precision rubber) now the question is should I use a little adhesive as well in some places
  9. O

    Water on drivers floor

    Well I knew I had a leak, the burb had been sitting long enuff. Removed the carpet from the driver's floor, mass backing soaked. Removed cowl, cleaned up around it, obviously going to reseal joint to help the situation. Ran the hose and saw there was a small leak in this area, but obviously...
  10. O

    Guidance, ideas

    Recently installed a wireless backup camera in my 90 suburban, auto vox brand off Amazon. Installation went fairly easy, tapped into the reverse lights power for the camera. The monitor simply plugs into the cigarette lighter and comes on when I move her into reverse. Well installed yesterday...
  11. O

    Yet another fuel gauge question

    Starting to troubleshoot my fuel gauge problem. Gauge reads past full, starting at the rear. Should I get a ohms reading from the purple/pink wire. Fuel sending unit is a delphi.
  12. O

    Exhaust manifold question

    Well I thought this might be easy, considering no broken bolts or studs, but no. Got a replacement, and yes it the same except for the flange where it meets the y. Well the y pipe is this and it seems that the replacement is too long or is this a removable sleeve in the y pipe. Any suggestions...
  13. O

    1990 suburban V1500, DRAC location

    Is there a DRAC on a 1990, either under the dash by the radio, or is integrated with the dash cluster, thanks in advance.
  14. O

    Manifold question

    Pulling the manifold as it cracked no issues so far. Except for this black bracket that's connected to the power steering pump. How th heck does it come off.
  15. O

    Mechanic in the Pacific Northwest

    This site has been a wealth of knowledge, but my mechanical skills are sorely lacking. Does anyone know of a squarebody mechanic in the Pacific Northwest, in Washington, but she will travel albeit a bit ruff. Thanks
  16. O

    Advice required

    1990 Suburban, V1500, 4x4, 5.7 tbi, New fuel pump, filter, coil, etc. A shot of ether and the vehicle starts right up, without it no. When it starts good to go, drive for hours but once you stop, you will need to bust out the ether again. Suggestions anyone, thanks.

Latest posts

Forum statistics

Threads
45,558
Posts
986,222
Members
38,643
Latest member
Hard
Top